Installation Guide

page 1
U21241T
08/07 Rev C
WARNING: RISK OF SHOCK
Electric current can cause painful shock or serious injury
unless handled properly. For your safety, always:
••
Turn off electrical power at fuse or circuit breaker box be-
fore wiring fixture to the power supply.
•• Turn off the power when you change lamps or perform other
maintenance.
•• Ground the fixture to avoid potential electric shocks and to
ensure reliable starting.
•• Double-check all connections to be sure they are tight and
correct.
•• Wear rubber-soled shoes and work on a sturdy wooden
ladder.
This fixture is designed for use in a circuit protected by a fuse
or circuit breaker and to be installed in accordance with local
electrical codes. If you are unsure about your wiring, consult a
qualified electrician or local electrical inspector, and check your
local electrical code.
WARNING: RISK OF INJURY
Some metal parts in the fixture may have sharp edges. To pre-
vent cuts and scrapes, wear gloves when handling the parts.
Account for small parts and destroy packing material, as these
may be hazardous to children.
Use flashlight or alternate light source to light work area during
installation.
Assistance may be required to support fixture during installa-
tion.
When drilling holes overhead, always wear safety glasses to
protect eyes.
INSTALLATION INSTRUCTIONSXWL232
Lamps not Included.
Water-tight fitting and Mounting Hardware Included-
(Chain and related hardware not included)
THIS FIXTURE HAS OPTIONAL MOUNTING
METHODS
Hardware requirements will depend on the mounting method.
Determine fixture location,orientation and mounting method,
before proceeding.
CHOOSE YOUR PREFERRED OPTION
SEMI-FLUSH MOUNTING
*FLUSH MOUNT / WALL MOUNT
CHAIN (SUSPENDED) MOUNTING
*To fully secure fixture to surface, use Flush Mount Option
FIXTURE PACKING LIST
Description Quantity
1) Plastic Fixture Housing ......................................... 1
2) Diffuser ................................................................... 1
3) Wireway Cover ...................................................... 1
4) Lampholder bracket .............................................. 2
5) Lampholder ............................................................ 4
6) ¼ Turn Fastener ..................................................... 2
7) Latch ..................................................................... 10
8) Mounting Bracket * ................................................ 2
9) Chain Arm Support * .............................................. 2
10) Water Tight Fitting * ............................................. 1
11) Wire Nut * ............................................................. 3
12) Wood Screw #8-32 x 1½" * ................................ 4
13) Screw #8-32 x 3" & Toggle Nut* ......................... 4
14) Washer * .............................................................. 4
15) Rubber Washer * ................................................. 2
*Contained in Parts Pack
IMPORTANT SAFETY INFORMATION
(Protect yourself. Read these instructions carefully and save them for future reference).
REQUIRED TOOLS
Safety glasses Drill
Ruler/Tape measure 3/32” Drill Bit
Flat blade screwdriver 3/16” Drill Bit
Phillips screwdriver 1/2” Drill Bit
Adjustable wrench Pliers
Figure 1