SDS

Page 3/7
Safety Data Sheet
acc. to OSHA HCS
Printing date 12/14/2016 Reviewed on 11/08/2016Rev. 7
Trade name: LITOCHROM STARLIKE (comp B)
(Contd. of page 2)
43.2.12
*
7 Handling and storage
·
Handling:
·
Precautions for safe handling
Ensure good vent ilation/ exhaustion at the wo rkplace.
Prevent formation of aerosols.
·
Information about protection against explosi ons and fires:
No special measures required.
·
Conditions for safe storage, including any incompatib ilities
·
Storage:
·
Requirements to be met by storerooms and receptacles:
Store in a cool locatio n.
Store only in the original receptacle.
·
Information about storage in one common s torage facility:
Not required.
·
Further information about storage conditions:
Store receptacle in a well ve ntilated area .
Keep receptacle tightly sealed.
Protect from heat and direct sunl ight.
·
Specific end use(s)
No further relevant inf ormation available.
*
8 Exposure controls/personal protection
·
Additional informat ion about design of technical systems:
No further data; see item 7.
·
Control parameters
·
Components with limit values that require monito ri ng a t the workplace:
The following constituent is the only constituent of the product which has a PEL, TLV or other recommended expo sure
limit.
At this time, the other constituents have no known exp osure limits.
CAS: 112-57-2 3,6,9-triazaundecamethylened iamine
WEEL Long-te rm valu e: 5 mg/m³
Skin; DSEN
·
Additional informat ion:
The lists that were valid during the creation were used as basis.
·
Exposure controls
·
Personal protective equipment:
·
General protective and hygienic measures:
Do not e at, drink, smoke or sniff while workin g.
Keep away from fo odstuffs, beverages and feed.
Immediately remove all soi led and contaminated clothing.
Wash hands before breaks and at the end of work.
Do not inhale gases / fumes / aerosols.
Avoid contact with the eyes and skin.
·
Breathing equipment:
Use suitable respiratory protective device in case of insuffi cient ventilation.
Short term fi lter device:
Filter B
·
Protection of hands:

Protective gloves
The glove material has to be impermeable and resistant to the product/ the substance / the prep aration.
Selection of the glove material on consideratio n of the penetration times, rates of diffu sion and the degradation
·
Material of gloves
The selection of t he suitable gloves does not only depend on the material, but also on further marks of quality and
varies from manufactu rer to manufacturer. As the product is a preparat ion of several sub stances, t he resistance of
the glove material can not be calculated in adva nce and has therefore to be checked prior to the application.
·
Penetration time of glove material
The exact break thro ugh time has to be found out by the man ufacturer of the protec tive gloves an d has to be
observed.
(Contd. on page 4)
US