Quick Start Guide

GETTING READY
1
Remove the cardboard spacer
between the Bonnet & Globe.
Remove the tape from around
the entryway.
Confirm that the side and rear
Bonnet tabs on both sides of
the unit are secured in their
corresponding slots.
Confirm that the Key on the
rear of the unit is located in
the pocket.
WHAT’S IN THE BOX1.1
PRE-CHECK1.2
• 15 Volt DC Power Supply
• Instruction Manual
• Quick Reference Guide
• Quick Start Guide
• Return & Repack Instructions
Welcome Kit
(1) Fully assembled Litter-Robot III Open Air
(1) Carbon Filter
(3) Waste Drawer Liners
Remove the cardboard spacers
between the Waste Drawer & Base.