Quick Start Guide

www.litter-robot.com
Instruction Manual available for download at
What do the lights mean?
Blue
Illuminated: Waiting and ready for use.
Flashing: Time to empty - Waste Drawer is full!
Action Needed:
Pressing the Button will cancel Drawer Full
Indication and Blue LED will be illuminated.
Yellow
Illuminated: Unit is running a clean cycle.
Note: Yellow LED will remain illuminated when the clean
cycle is paused by pushing any of the three buttons.
Flashing 1x per Second:
1. Bonnet has been removed, or
2. Cat Sensor was activated during clean cycle.
Action Needed:
Pressing the Button will continue to pause the
unit with Yellow LED illuminated.
Pressing the Button will then continue the
clean cycle.
Pressing or Buttons will abort the
clean cycle and return the Globe to home position.
Flashing 2x per second: Pinch Detect was
activated.
Action Needed:
Pressing the Button will cancel this mode and
send Globe to home position.
Red
Illuminated: Cat Sensor was activated while unit
was ready and waiting for use. Wait-time
(standard 7 minutes) in process.
Action Needed:
Pressing the Button will cancel the Cat Sensor
timer, reset the baseline, and the Blue LED will then
be illuminated.
Flashing:
1. Too much weight in the unit, or
2. Cat Sensor activated continuously for more
than 2 minutes (cat won't leave unit).
Action Needed:
Pressing the Button will cancel the fault mode
assuming excessive weight has been removed. Unit
will either continue clean cycle with Yellow LED
illuminated, or return to Blue LED illuminated if unit
was originally in home position
Power Button
Illuminated: Unit operating in Battery Backup
mode.
Blue and Yellow
Illuminated: Unit is in 8 hour lock-out mode.
Fault Indicators
Setting up your Litter-Robot Open Air™
Step 1: After removing unit from box make sure to
remove cardboard spacer between Bonnet and Globe.
Step 2: Locate Power Supply in pocket of top
cardboard insert. Locate Instruction Manual and keep
in a safe place.
Step 3: Find a convenient electrical outlet and
location for the Litter-Robot - the cord is 6 feet long.
Step 4: Position the Litter-Robot on a flat and sturdy
surface within range of an electrical outlet.
Note: The Litter-Robot may be used on carpeted surfaces,
but the Cat Sensor sensitivity may be slightly reduced.
Step 5: Add clumping litter. Pour 10 lbs. (weight) or
approximately 1 1/2 gallons (volume) of litter into the
Globe by pouring into the entry/opening. You may
also use one of the cardboard corner braces from the
original packaging as a trough/funnel for the initial fill.
Step 6: Spread litter flat in bottom of Globe and
verify that litter does not exceed the raised Fill Line.
Step 7: Plug in Power Supply (15VDC Adapter) at
electrical outlet and insert small plug end into socket
at rear of unit.
Step 8: Press the Power Button. Globe will start to
rotate counter clock-wise with Yellow LED illuminated
indicating the unit is running a clean cycle. Wait for
the unit to complete the clean cycle (takes approxi-
mately 2 1/2 minutes). Blue LED will illuminate after
unit completes clean cycle indicating it is ready for
use.
Note: If upon pressing the power button, the Globe starts but
then stops and the Red LED starts to flash, there is too much
weight in the unit. Check that you have not over filled the
Globe, and check to make sure nothing is in the Waste Drawer.
Remove excess litter or weight and then press the Reset
Button to continue the clean cycle.
Flashing sequentially: Motor obstructed or jammed.
Flashing sequentially: Unit cannot find the dump
position.
Flashing sequentially: Unit cannot find home
position.
- -
Flashing at same time: Unit cannot find dump or
home position.
QUICK REFERENCE GUIDE