Use and Care Manual
Construction Manual
© 2007 Little Cottage Co.
Page 3
Gambrel Barn Units - 8x8 through 12x24
13
With the corners secure, now drive 2½” screws
through the end wall’s base 2X and into the oor
every 16.”
16
From the inside, drive a 2½” screws through the base
2X and into the oor at one corner.
14
Locate the remaining end wall section with the door
and set in place.
18
Locate the siding strip that ts below the door
opening. Position as shown above and attach using
2½” screws every 8-12.” Use a straight edge to
ensure that the top of siding is ush with oor.
15
From the outside, hold the end wall section rmly in
place.
17
Then, drive a 2½” screw through the base 2X and into
the oor at the opposite corner. Repeat steps #11
and #12. After wall is in place, remove spacer.
Remove spacer after
wall is in place
Gambrel Barn Units- 8x8 through 16x24
®