Product Manual

s WARNING

Before Getting Started

Read and follow safety instructions. Refer to product data plate(s) for additional operating instructions and specications.

s CAUTION

s WARNING

This is the safety alert symbol. When you see this symbol on your pump or in this manual, look for one of the following

signal words and be alert to the potential for personal injury or property damage if ignored:

s WARNING

DANGER

s WARNING

NOTICE

warns about hazards that will cause serious personal injury, death or major property

damage if ignored.

warns about hazards that can cause serious personal injury, death or major property

damage if ignored.

warns about hazards that will or can cause minor personal injury or major property

damage if ignored.

indicates special instructions which are important but not related to hazards. Carefully read and

follow all safety instructions in this manual and on pump.

s WARNING RISK OF ELECTRIC SHOCK - This pump is supplied with a grounding conductor and grounding type

attachment plug. To reduce risk of electric shock, be certain that it is connected only to a properly grounded,

grounding-type receptacle. Disconnect power before working on or around the sump pump or battery backup system.

This equipment should be installed by technically qualied personnel. Failure to install in compliance with national, local

electrical, and within Franklin Electric recommendations may result in electrical shock or re hazard, unsatisfactory

performance, or equipment failure. Installation information is available through pump manufacturers and distributors, or

directly from Franklin Electric at our toll free number 1-800-701-7894.

This equipment must not be used by children or persons with reduced physical, sensory or mental abilities, or lacking in

experience and expertise, unless supervised or instructed. Children may not use the equipment, nor may they play with

the equipment or in the immediate vicinity.

If the power cord is damaged, it must only be replaced by qualied personnel.

• Keep work area clean, well-lit, and uncluttered.

• Keep safety labels clean and in good condition.

• Wear safety glasses while installing or performing maintenance on pump.

• Do not run pump dry. Fill pump with water before starting or pump will be damaged.

• Make sure all ELECTRICAL POWER IS OFF before connecting any electrical wires. Wire sump pump system for

correct voltages. Follow all pump wiring instructions provided in the “Wiring” section of this manual.

s CAUTION

• Keep work area clean, well-lit, and uncluttered.

• Keep safety labels clean and in good condition.

• Wear safety glasses while installing or performing maintenance on pump.

• Do not run pump dry. Fill pump with water before starting or pump will be damaged.

• Make sure all ELECTRICAL POWER IS OFF before connecting any electrical wires. Wire sump pump system

for correct voltages. Follow all pump wiring instructions provided in the “System Wiring Diagram” and “Electrical

Connections” sections of this manual.

s WARNING