Installation & Assembly

8 5
Minimum Clearance Zones
Set-up:
PLACE BLOWER ON LEVEL, FIRM GROUND AWAY FROM WATER.
MINIMUM CLEARANCE ZONES
INFLATABLE SIZE:
6.6 ft. (2 m)
Make sure that there is a 6.6 feet (2 m) obstacle-free zone
around the product, including the slide and overhead.
4.33W x 4.5D x 5.42H feet (1.32 x 1.37 x 1.65 m)
6.6 ft. (2 m)
5.42 ft.
(1.65 m)
6.6 ft. (2 m)
4.5 ft.
(1.37 m)
6.6 ft. (2 m)
4.33 ft. (1.32 m)
6.6 ft.
(2 m)
6.6 ft.
(2 m)
1
2
Unfold inatable and spread out as shown.
Deflation & Storage
TURN BLOWER OFF TO FULLY DEFLATE.
3
GFCI
only
1. Plug GFCI into receptacle.
2. Press reset button: indicator light
should be ON.
3. Press test button: indicator light
should be OFF.
Press reset button for use. Do not use if
test fails.
WARNING:
If the blower remains ON when the “test”
button is pushed, the unit is NOT working
properly.
DO NOT USE THE UNIT. Take the unit to a
certied electrician immediately.
Indicator
light
Turn the blower OFF
Leave the Wacky Wash™ inated until all
remaining water has evaporated and the
inatable is dry.
2
4
Unstrap the tube from blower and allow the
Wacky Wash™ to fully deate.
5
Fold up and store. HINT: It is helpful to smooth and
atten inatable as you fold.
1
Dettach the garden
hose from the end of
hose assembly.
Disconnect
Turn OFF
garden hose.
Remove and drain
hose assembly from
Wacky Wash™. Wrap
it up with no kinks.
Place tube over blower. Wrap strap around blower
and through each loop located on each side of tube.
Thread strap through buckle and pull tight.
Secure velcro strap around blower.