8 HP SKID MOUNT 8184-04-01 18 HP SWING ARM PARTS / OPERATOR’S MANUAL Original Language Instructions Rev.
CALIFORNIA WARNING Proposition 65 Warning Diesel engine exhaust and some of its constituents are known to the State of California to cause cancer, birth defects and other reproductive harm. The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm.
TRUCKLOADER IMPORTANT MESSAGE On behalf of everyone at Little Wonder, we would like to thank you for your purchase of a Little Wonder TruckLoader. This professional truckloader was designed to the highest standards to ensure many hours of uninterrupted service. This machine comes with an Operators / Parts Manual. The useful life and good service you receive from this machine depends to a large extent on how well you read and understand this manual.
SAFETY TRUCKLOADER NOTICE !!! This symbol means: Unauthorized modifications may present extreme safety hazards to operators and bystanders and could also result in product damage. Little Wonder strongly warns against, rejects and disclaims any modifications, add-on accessories or product alterations that are not designed, developed, tested and approved by Little Wonder Engineering Department.
SAFETY TRUCKLOADER PREPARING FOR SAFE OPERATION Operator preparation and training Read the Operation & Safety Manual - If an operator or mechanic cannot read English, it is the owner's responsibility to explain this material to them. If any portion of this material is unclear, contact your factory representative for clarification. - - - - Decals regarding safety and/or unit operations have been placed on parts of the machine. Adhere to the warnings and instructions depicted in these decals.
SAFETY TRUCKLOADER OPERATION SAFETY Interrupting operation In general - - Use extra care when loading or unloading the truckloader onto a trailer or truck. Before leaving the operator's position: - Move throttle to the SLOW position. - Shut off the engine and remove the key. - Slow down and use caution when making turns and crossing roads and sidewalks. - - Do not run the engine in an enclosed area where dangerous carbon monoxide fumes can collect.
SAFETY TRUCKLOADER MAINTENANCE SAFETY In general - Maintain machine according to manufacturer's schedule and instructions for maximum safety and best results. - Park supporting vehicle on level ground. - Rotating Impeller: Do not attempt to remove materials from intake or discharge when truckloader is running or impeller is still rotating. - Never allow untrained personnel to service machine. - Adjust or repair only after the engine has been stopped and the fan has quit rotating.
SAFETY BATTERY Battery acid is caustic and fumes are explosive and can cause serious injury or death. TRUCKLOADER WARNING - Keep the machine and fuel containers in a locked storage place to prevent tampering and to keep children from playing with them. To reduce the risk of personal injury when working near a battery: - Do not store the machine or fuel container near heating appliances with an open flame such as a water heater or an appliance with a pilot light.
TRUCKLOADER LABELS P/N MP100108 P/N MP100109 7
SET UP INSTRUCTIONS mbly Instructions TRUCKLOADER SKID MOUNT POWER UNIT utions 1 – Power Unit: Includes Fuel Cell and Battery and Box semble 1 – Discharge Stack Assembly (Stack / Elbow kaging Combination) 1 – 7” dia. X 30” Metal Discharge Hose 1 – 10’ Intake Hose (10” dia.) 1 – Intake Nozzle (10” dia.) 1 – Intake Nozzle Handle 1 – Intake Hose Connector 1 – Intake Hose Support Strap (10” dia.
arm from pallet. Note: Lift points on power unit are for installin STEP 3: Stack Assembly power unit from hitch mount / swing ar all Hitch Mount Swing Arm to receiver of vehicle. overhead is available. SETwinch UP INSTRUCTIONS nt power unit utilizing the supplied (A) Attach Discharge Stack to blower housing uti TRUCKLOADER ½” X 1” bolts, washers, and nuts. 8 – (3/8” X 16 X 1 ¼”) bolts. points on power unit are for installing or removing STEP 3: Stack Assembly er unit from3.
ilizing the Same Size Support Band. om Mast utilizing (B) Install Boom Assembly to receiver on washer,SET and UP nuts.INSTRUCTIONS rear of discharge stack. TRUCKLOADER B Assembly Instructions, cont. Assembly Instructions, cont.
CONTROLS TRUCKLOADER KEY SWITCH (A) Turn clockwise to "START" position to start engine. Release key to turn to "RUN" position. Turn counter-clockwise to "STOP" the engine. C A D THROTTLE (B) Controls engine speed. CHOKE (C) Move to the "CHOKE" position to apply the choke. Move to the "RUN" position to remove the choke. B FUEL SHUT OFF (D) Rotate to shut off the fuel whenever transporting the machine or during storage. Rotate to allow fuel to flow to engine during operation.
OPERATION TRUCKLOADER INTENDED USE This unit is intended for vacuuming leaves, clippings and other similar sized organic material from the ground into a truck or trailer. Large sized or long stringy material will tend to clog. Vacuuming sand, rocks, and hard litter will shorten the life of this machine and may damage the machine or parts of it. PRE-OPERATION CHECK LIST (OPERATOR’S RESPONSIBILITY) - - - - 12 Review and follow all safety rules and safety decal instructions.
OPERATION TRUCKLOADER OPERATING This machine has been designed for two methods of vacuuming debris: With the handle of the Intake Nozzle in the operator’s hands, move the nozzle back and forth in a sweeping motion over the debris Rotate Intake Nozzle to lay sideways on the ground. By placing the Nozzle in this position, debris can be raked into the nozzle by an operator.
MAINTENANCE / STORAGE DAILY MAINTENANCE - Inspect the intake hose connector to make sure it is securely fastened to the intake cover assembly - Inspect the hose, chute, chute liner, and blower housing liner for wear. Replace worn parts or have them repaired. - Tighten any loose fasteners. ENGINE OIL - Check the oil level daily. - Change after the first day of operation and then according to the engine manual. - See the engine manual for oil specifications and checking procedure.
SPECIFICATIONS TRUCKLOADER Model Engine Displacement cm3(cu. in) Starter Fuel Capacity Oil Capacity Vacuum Hose Discharge 8183-04-01 8184-04-01 18HP Vanguard 18HP Vanguard 479 (29.23) 479 (29.23) Electric / Pull Start Electric / Pull Start 1.5 Gal. EPA (Low Perm) 1.5 Gal. EPA (Low Perm) 1.36 – 1.42 Liter 1.36 – 1.42 Liter 10”dia.x 10’ 10”dia.
PARTS TRUCKLOADER 11 10 2 8 7 12 9 18 14 15 6 13 4 1 17 16 5 16 3
PARTS TRUCKLOADER ITEM PART NO. DESCRIPTION QTY. 1 MP020035.31 Housing Assembly 1 2 MP020036.31 Dishcharge Stack 1 3 MP020037.10 Intake Cover Assembly 1 4 MP020038.17 Door, Intake Cover 1 5 MP020039.17 Intake Hose Connector 1 6 MP020034 18HP Liner Kit 1 7 MP020040.17 Nozzle Assembly 1 8 MP020041.17 Handle, Pick-Up Tube 1 9 MP020042.17 Strap, 11.25" Intake Hose 1 10 MP020043.17 Boom Mast 1 11 MP020044.17 Boom Arm 1 12 MP020045.
2 YEAR LIMITED SERVICE AND WARRANTY POLICY FOR LITTLE WONDER TRUCKLOADERS All LITTLE WONDER TRUCKLOADERS are warranted against defects in material and workmanship for a period of two (2) years from the date of purchase, under the following terms and conditions. LITTLE WONDER will repair or replace, at its option, any part or parts of the product found to be defective in material or workmanship during the warranty period. Warranty repairs and replacements will be made without charge for parts or labor.
