Technical Manual

MOPSlcd4 Hardware Description
P488m113.doc
JUMPtec

Industrielle Computertechnik AG
Page: 23 of 38
Onboard C&T VGA
Block Diagram
Intern
PCI-
BUS
HiQV64
with 2 MB RAM
CRT
internal
panel connector
plug-and-play
Supported Display Types
The MOPSlcd4 supports a vast variety of panels all configured by a dedicated cable for each panel. There is no
jumper setting or software setup required. Since practically all LCD’s have different connectors, pinout or LCD
voltages, this is the easiest and safest way to configure different panels.
The MOPSlcd4 BIOS supports different panel types, which are identified via the video BIOS by reading the
configuration on internal panel connector.
Power Supply
The on board 3.3V-circuitry and low-voltage panels are powered by their own separated voltage regulators, the
one for the LCD is mounted on the adapter cable. If the used backlight converter needs +12V, supply system
also with +12V.
The LC-Display Interface
Connecting a Display
Many different panel adapters for a wide spread variety of displays are available through JUMPtec
®
. If you use
one of those adapters supplied by JUMPtec
®
, configuration is very easy:
1. Check, whether you have the correct adapter and cable for the panel you plan to use. Inspect the cable for
damages.
2. Disconnect power from your System.
3. Connect the panel adapter to the internal LCD connector (X6) on MOPSlcd4.
4. Connect the other end of the cable to your display.
5. Connect the backlight converter.
6. Supply power to your system
7. If no picture appears on your display, you should connect a CRT monitor to the CRT-connector (X5).
If you still don’t see any improvement, you may consider contacting the dealer for technical support.
Current panel information from the JUMPtec
®
-Website
To find out whether your panel is supported, you should check the JUMPtec
®
support pages on the Internet for
actual panel lists. We regularly update the list of panels that have been tested with the MOPSlcd4.