User Manual
Table Of Contents
- introduction
- system overview
- safety
- installing SPICE
- maintenance
- glossary
- installation checklist
- unit specifications
Littlefeet, Inc. 45
SPICE™ Hardware Guide FIVE: maintenance
550008 Rev. A replace bSPICE batteries
Reconnect the fuse and fuse holder. Put the batteries into the enclosure, taking care to not
damage the connector. Make sure that the gasket around the battery enclosure is in place.
figure 42. replacing battery pack
note The unit will be unavailable for maintenance for two to five minutes while the unit reboots.
!
CAUTION Be sure to properly dispose of the old batteries. Follow the manufacturer’s instructions for
disposal.
figure 43. replaced battery
Replace the service door (Figure 40), torque down the screws to 25 in-lbs (2.8 N-m), close the
unit door, torque down the screws to 30 in-lbs (3.4 N-m), and reconnect power to the bSPICE.
Access the SST using your laptop and check that the battery alarm is no longer present. See the
SPICE Software Guide for details. If the alarm persists, replace the unit.