User Manual

appendix A: installation checklist SPICE™ Hardware Guide
banding details 550008 Rev. A
64 Littlefeet, Inc.
banding details
This section contains details about using the banding provided with SPICE units and with the
power supply.
The power supply includes one band. Two may be used, but the second band is not provided.
SPICE units require two bands.
The band comes attached to the mounting hardware (Figure 54).
figure 54. band and mounting hardware
One end of the band is secured to the mounting (Figure 55).
figure 55. secured end - detail
Measure the distance around pole at the height of the installation. Cut the banding to the length
of the pole plus 6 inches (15 cm) for the “tail” of the banding. If the banding is too short, contact
Littlefeet for a longer strap.
Slide the band through the slots on the bracket, as detailed on page 19 for the power supply,
page 21 for the bSPICE, or page 30 for the cSPICE (Figure 56). For small poles, slide the
banding through one slot on the small bracket, then through both slots of the unit or power