User Manual
Table Of Contents
- introduction
- system overview
- safety
- installing SPICE
- maintenance
- glossary
- installation checklist
- unit specifications
appendix A: installation checklist SPICE™ Hardware Guide
banding details 550008 Rev. A
66 Littlefeet, Inc.
Bend the loose end of the banding around the retainer. Make the bend tight using a hammer
(Figure 58).
figure 59. tighten the bend
Bend the banding so that the carriage bolt can connect the two retainers. Fasten the banding
around the pole (Figure 60) using the nut provided. When tightened, there should still be a 1
inch (2.5 cm) adjustment gap between the retainers. Tighten the straps as directed.
figure 60. installed band