User Manual

Littlefeet, Inc. 57
appendix A
installation checklist
This appendix summarizes the steps that must be taken in order to install a SPICE unit, from
taking it out of the box to integrating it into the network. It is assumed that:
 Sites and settings (channel numbers, power levels) for units have already been chosen and
entered in the Installation Form.
 The OMC is already set up (see the Quick Start Guide that accompanies the OMC).
 You have obtained and configured a laptop to be used as an SST (see the chapter on SST
basics and setup in the SPICE Software Guide).
unpacking unit
The first step is to unpack and check the unit. Follow the steps in the Quick Start Guide that
accompanies the unit.
Tools and equipment needed:
 SPICE Quick Start Guide for unit
 Power source
 RF coverage (to check the unit’s modem)
 Laptop to access the SST
 Data-enabled SIM card for built-in modem
installing unit
After transporting the unit to the location where it is to be installed, you will install the unit.
Follow the steps in the chapter four.
Tools and equipment needed:
 Equipment listed in chapter four (unit, mounting bracket, etc.)
 Suitable location for unit
 Appropriate power source
programming/commissioning unit
After installing the unit, you will need to program it so that it knows which frequencies to use,
etc. You can also commission the unit prior to installation. Follow the steps in the chapter on
using the SST in the SPICE Software Guide.