08.2020 - 1.100.
Do you have all the tools needed? 1 M5 x 30 PANHEAD SCREWS x 4 WALL ANCHOR x 4 2 7 mm Make sure that you have the correct type of anchors for the wall that you’re mounting the device (i.e: concrete, drywall) Hammer Drill Screwdriver Laser Meter Tape Measure Pencil Bubble Level Tape Template INSTRUCTIONS All instructions here are for Litum Anchor/Gateway Outdoors referred to as “Anchor/Gateway(s)” in the document. CAUTION The anchor/gateway is not suitable for mounting on metal surfaces.
WHERE TO MOUNT 1 The anchor/gateway must be mounted on walls, not on ceilings. CEILING 2 All anchors/gateways must be mounted consistenly to the same height across the facility. CEILING Anchor/Gateway h ideal = 4 m (13 ft) h min = 2.5 m (8 ft) WALL FLOOR If it is required to install the anchor/gateway higher than 4m (13 ft), please consult Litum. FLOOR WHERE TO MOUNT 3 If you need to mount anchor/gateway close to a corner, make sure to stay away at least 50 cm (1.5 ft).
HOW TO MOUNT 1 LOCATE & MARK Print the anchor/gateway drilling template. Use it with bubble level and place it on the wall. 4 INSTALL SCREWS Firmly install all screws until they are pulled flush against the plastic surface of the anchor. All screws must be firmly installed to prevent unwanted movement of the anchor. Ensure the device is securely fastened to the wall. 2 DRILL & INSERT WALL PLUGS Drill the four holes on the template and insert wall plugs.
OPERATION When the device is connected to a stable power supply, service LED should start to blink. The service LED will light up and remain steady when the device is communicating with a server. RF Comm LED indicates RF communication is active. Battery Switch TCP LED Service LED RF Comm LED The device has an internal backup battery. Turn the backup battery switch on to ensure the device continues to work during power outage or emergencies.
S U ER TT LE Please print the anchor drilling template on US Letter size paper. Please check that the template printout aligns with Litum Anchor/Gateway Outdoors screw holes before proceeding.
A4 R PE PA Please print the anchor drilling template on A4 size paper. Please check that the template printout aligns with Litum Anchor/Gateway Outdoors screw holes before proceeding.
FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
