0 .2020 - 1.110.
Do you have all the tools needed? 1 M5 x 30 PANHEAD SCREWS x 2 WALL ANCHOR x 2 2 7 mm Make sure that you have the correct type of anchors for the wall that you’re mounting the device (i.e: concrete, drywall) Hammer Drill Screwdriver Laser Meter Tape Measure Pencil Bubble Level Tape Template INSTRUCTIONS All instructions here are for Litum Anchor/Gateway referred to as “anchor/gateway(s)” in the document. CAUTION Anchor/Gateway is not suitable for mounting on metal surfaces.
WHERE TO MOUNT 1 The anchor/gateway can be mounted both on walls and ceilings. This document only refers to wall mounting. CEILING 2 All anchors/gateways must be mounted consistently at the same height from the floor. CEILING Anchor/Gateway h ideal = 4 m (13 ft) When mounted on the ceiling, ensure that the antenna on the device is pulled down for proper covarage. FLOOR 3 If you need to mount the anchor/gateway close to a corner, make sure to stay away at least 50 cm (1.5 feet).
HOW TO MOUNT 1 LOCATE & MARK Print the anchor/gateway drilling template. Use it with bubble level and place it on the wall. 37 m DRILL & INSERT WALL PLUGS Drill the two holes on the template and insert wall plugs. 37 m m (1 3 2 m (1 .46 in c) CABLE CONNECTION Insert the power outlet into the plug at the back of the anchor/gateway. 4 .46 in c) INSTALL SCREWS & HANG THE DEVICE Secure the screws in place using the screwdriver.
PLUG IN Plug in the anchor/gateway to a 110/220 V AC power outlet. When the device is connected to a stable power supply, a green LED should start to blink on the side of the device. OPERATION The green LED will light up and remain steady when the device is communicating with a server. Additional devices with RS232 or RS485 communications can be connected to the device through the optional RJ11 port. Please contact Litum for supported devices.
US LE TT ER 37 mm (1.46 inch) Please print the anchor drilling template on US Letter size paper. Please check that the template printout aligns with Litum Anchor/Gateway screw holes before proceeding.
A4 PA PE R 37 mm (1.46 inch) Please print the anchor drilling template on A4 size paper. Please check that the template printout aligns with Litum Anchor/Gateway screw holes before proceeding.
FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
IC Warning This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
