Operation Manual

9 GB/IE
Initial useSafety / Preparation / Prior to installation / Initial use
light
5
now match the position of the ceiling
screws.
Carefully push the LED ceiling light
5
against
the ceiling until you feel resistance, then turn the
LED ceiling light
5
to the right (direction see
arrow decal) until you hear a „click“. The LED
ceiling light
5
is locked into place and instal-
lation is complete.
Verify again, the LED ceiling light
5
is locked
into all three ceiling screws
9
. Otherwise re-
peat this process.
You may now remove the decals
1
from the
LED ceiling light
5
and ceiling.
Replace the fuse or switch on the circuit breaker
in the fuse box (I position).
Your LED ceiling light
5
with Bluetooth speaker is
ready for use.
Installing the wall bracket
Install the wall bracket for the remote control
25
using the screws
27
or adhesive pads
26
as
shown in Figure E.
Inserting / replacing batteries
Note: The remote control requires two batteries type
AAA / LR03 (included).
Slide the battery case cover (reverse) down by
approx. 1 cm to open and then lift off the cover.
Insert two batteries of the included type
AAA / LR03 in the battery compartment. Please
note the correct polarity!
Slide back the cover to close the battery com-
partment.
Your remote control is ready to use.
Operating the light by switch
The LED ceiling light
5
may be switched on
and off using the wall switch. Here the bright-
ness will always be 100 %. All other functions
are solely controlled via remote control.
Using the remote control
ATTENTION! The functions of the remote control
can only be used after switching the LED ceiling
light
5
on with the wall switch.
Switching the light on / off
1. Switching the light on
Press the “ “ button (lighting)
13
, to switch the
LED ceiling light
5
on. A beep confirms recep-
tion of the signal.
2. Switching the light off
Press the “ “ button (lighting)
14
, to switch
the LED ceiling light
5
off. A beep confirms
reception of the signal.
Dimming the light
1. Increasing brightness
Press the “ “ button Dimmer +
15
, to increase
the brightness. A beep will sound when reach-
ing the maximum brightness. Briefly pressing this
button will gradually increase the brightness as
pressed. Holding the “
“ button Dimmer +
15
will automatically increase the brightness to the
maximum.
2. Reducing the brightness
Press the “ “ button Dimmer –
16
, to reduce
the brightness. A beep will sound when reaching
the minimum brightness. Pressing it briefly will
gradually decrease the brightness as pressed.
Holding the “
“ button Dimmer –
16
will auto-
matically decrease the brightness to the minimu m.
30 minute timer
1. Activating the timer
Press the “ “ button
17
to switch the LED ceil-
ing light
5
off automatically. A double beep
confirms reception of the signal.
The light and the Bluetooth function (music) will
automatically switch off after approx. 30 minutes.