Use and Care Manual

Installation
Initial Setup
Figure 2
Initial Setup:
1. Your fan will come packaged in two separate pieces. Carefully remove fan from
box and remove any packaging material.
2. Extend power cord and inspect for any signs of damage. If damaged, refer to
Technical Support.
3. Align six snap joints on upper body of fan to the snap joint holes on the base of
fan.
4. Push upper body of fan towards control panel, until locked into place.
5. Plug into wall outlet.
6. Turn on unit by pressing ON/OFF button on fan or remote.
7. Refer to Operating the Fan for more information on operating your fan.
3
Upper Body
PUSH
Snap Joints
Snap Joint Holes
Base
Control Panel