Instructions / Assembly

ManualsBrandsLivex Lighting ManualsLightingAero 1-Light Brushed Nickel Sconce

ASSEMBLING & INSTALLATION INSTRUCTIONS

The drawing shown may not exactly match the product enclosed.

However, the installation instructions do apply to this product.

10101 10103

 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.

ASSEMBLING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker box. Remove old fixture

and all hardware from Junction Box. Carefully unpack your new

fixture and lay out all the parts on a clear area. Take care not to lose

any small parts necessary for installation.

2. Thread the two mounting screws about 1/4” into the pre-drilled

holes in the mounting plate, spaced about the same distance apart

as the holes in the fixture back plate. Attach the mounting plate to

the junction box using two junction box screws as shown. The side

of the mounting plate marked “GND” must face out. The junction

box is not included.

3. Guide fixture wires through hole in center of mounting plate.

4. Follow wiring instructions carefully (see fig.2).

5. Raise the lamp body(B) onto the mounting plate, aligning the holes

with mounting screws, then lock it securely with the ball nuts(C).

6. Install the light bulbs(not included) in accordance with the fixture’s

specifications. NOTE: DO NOT EXCEED THE MAXIMUN

WATTAGE RATING!

7. Raise the glass(A) insert the cover of lamp holder, by turning it

clockwise until tight.

CONNECTING THE WIRES (Fig.2)

1. Connect the electrical wires as follows. Connect the Black wire from

the fixture to the black house (hot) Wire. Connect the white wire from

the fixture to the white (neutral) house wire. Make sure all wire nuts

are secured. You may wrap the connections with electrical tape. If

your outlet box has a ground wires (green or bare copper) connect

fixture’s ground wire to it. Otherwise attach the bare copper fixture

wire to the green ground screw on the mounting plate.

2. Tuck the wire connections neatly into the wall junction box.

Your installation is now complete. Return power to the junction

box and test the fixture.

Fig.1

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black(Hot)

FIXTURE

WIRES

White or

Ribbed

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

White

(Neutral)

HOUSE

WIRES

Green or Bare

Copper(Ground)

Thank you for purchasing a LIVEX product.

Need assistance with parts or assembly? Please call customer service at: 800-761-8056

Or visit us online at: WWW.LIVEXLIGHTING.COM

FIG.2