Instructions / Assembly

ManualsBrandsLivex Lighting ManualsLightingAero 2 Light Textured Black ADA Wall Sconce with Hand Blown Satin Opal White Twist Lock Glass

ASSEMBLING & INSTALLATION INSTRUCTIONS

The drawing shown may not exactly match the product enclosed.

However, the installation instructions do apply to this product.

10102 10104

 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.

ASSEMBLING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker box. Remove old fixture

and all hardware from Junction Box. Carefully unpack your new

fixture and lay out all the parts on a clear area. Take care not to lose

any small parts necessary for installation.

2. Thread the two mounting screws into the pre-drilled holes in the

crossbar, spaced about the same distance apart as the holes in the

fixture back plate. Attach the crossbar to the junction box using two

junction box screws as shown. The side of the mounting plate

marked “GND” must face out. The junction box is not included.

3. Follow wiring instructions carefully.(see fig.2)

4. Attach the back plate of the lamp body (B) onto the junction box,

aligning screws on crossbar with mounting holes and lock it

securely with the ball nuts (C).

5. Install the light bulbs(not included) in accordance with the fixture’s

specifications. NOTE: DO NOT EXCEED THE MAXIMUN

WATTAGE RATING!

6. Raise the glass(A) insert the cover of lamp holder, by turning it

clockwise until tight.

CONNECTING THE WIRES (Fig.2)

1. Connect the electrical wires as follows. Connect the Black wire from

the fixture to the black house (hot) Wire. Connect the white wire from

the fixture to the white (neutral) house wire. Make sure all wire nuts

are secured. You may wrap the connections with electrical tape. If

your outlet box has a ground wires (green or bare copper) connect

fixture’s ground wire to it. Otherwise attach the bare copper fixture

wire to the green ground screw on the mounting plate.

2. Tuck the wire connections neatly into the wall junction box.

Your installation is now complete. Return power to the junction

box and test the fixture.

Fig.1

10104

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black(Hot)

FIXTURE

WIRES

White or

Ribbed

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

White

(Neutral)

HOUSE

WIRES

Green or Bare

Copper(Ground)

Thank you for purchasing a LIVEX product.

Need assistance with parts or assembly? Please call customer service at: 800-761-8056

Or visit us online at: WWW.LIVEXLIGHTING.COM

FIG.2