Installation Guide

ManualsBrandsLivex Lighting ManualsBathroom & Wall LightingSutter 12-in W 1-Light Brushed Nickel Modern/Contemporary Wall Sconce

ASSEMBLING & INSTALLATION INSTRUCTIONS

The drawing shown may not exactly match the product enclosed.

However, the installation instructions do apply to this product.

10131 10132 10133

 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.

 WARNING: PLEASE REMOVE GLASS SHIM COVERING BEFORE USING ! ! !

MOUNTING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker box. Remove old fixture and

all hardware from Junction Box.

2. Carefully unpack your new fixture and lay out all the parts on a clear

area. Take care not to lose any small parts necessary for installation.

3. Drilling two holes in the wall, distance and the same distance from

the keyhole of mounting plate, then loaded plastic anchors. Attach

the mounting plate to the wall, aligning the plastic anchors and

junction box, lock it securely with the two wood screws and the two

box screws. The side of the mounting plate marked “GND” must

face out. The junction box is not included.

4. Guide fixture wires through hole in center of mounting plate.

5. Follow wiring instructions carefully (see fig.2).

6. Place the lamp body over the mounting plate, aligning the

backplane holes with screw hole of the mounting plate on side, then

lock it securely with mounting screws.

7. This lamp luminary is LED, the manufacturer has been installed.

CONNECTING THE WIRES (Fig.2)

1. Connect the electrical wires as follows. Connect the Black wire from

the fixture to the black house (hot) Wire. Connect the white wire from

the fixture to the white (neutral) house wire. Make sure all wire nuts

are secured. You may wrap the connections with electrical tape. If

your outlet box has a ground wires (green or bare copper) connect

fixture’s ground wire to it. Otherwise attach the bare copper fixture

wire to the green ground screw on the mounting plate.

2. Tuck the wire connections neatly into the wall junction box.

Your installation is now complete. Return power to the junction

box and test the fixture.

WHITE

HOUSE

Black

WIRES

(

Hot

)

FIXTURE

WIRES

BLACK

WIRES

FIXTURE

Bare

FIXTURE

WIRES

(Ground)

HOUSE

(

Neutral

)

WIRES

White

Green or

WIRES

HOUSE

Copper(Ground)

GREEN

Thread

Thank you for purchasing a LIVEX product.

Need assistance with parts or assembly? Please call customer service at: 800-761-8056

Or visit us online at: WWW.LIVEXLIGHTING.COM

FIG.2

FIG.1

Summary of content (1 pages)

PAGE 1
ASSEMBLING & INSTALLATION INSTRUCTIONS The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product. FIG.1 10131 10132 10133 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER. ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR. WARNING: PLEASE REMOVE GLASS SHIM COVERING BEFORE USING ! ! ! MOUNTING THE FIXTURE (Fig.1) 1. Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box. 2.