Operating Guide

ManualsBrandsLivex Lighting ManualsOther1-Light Chrome Bath Light with Satin Glass Shade

ASSEMBLING & INSTALLATION INSTRUCTIONS

The drawing shown may not exactly match the product enclosed.

However, the installation instructions do apply to this product.

1031 1032 1033

 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.

ASSEMBLING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker box. Remove old fixture and

all hardware from Junction Box. Carefully unpack your new fixture

and lay out all the parts on a clear area. Take care not to lose any

small parts necessary for installation.

2. Thread the two mounting screws about 1/4” into the pre-drilled

holes in the mounting plate, spaced about the same distance apart

as the holes in the fixture back plate. Attach the mounting plate to

the junction box using two junction box screws as shown. The side

of the mounting plate marked “GND” must face out. The junction

box is not included.

3. Guide fixture wires through hole in center of mounting plate.

4. Follow wiring instructions carefully. (see fig.2)

5. Raise the lamp body (C) onto the mounting plate, aligning the

mounting holes with mounting screws, then lock it securely with the

ball nuts (D). Attach the glass shade(B) to the lamp holder, then

lock it securely with the check ring (A).

6. Install the light bulbs (Not included) in accordance with the fixture’s

specifications. NOTE: DO NOT EXCEED THE MAXIMUM

WATTAGE RATING!

CONNECTING THE WIRES (Fig.2)

1. Connect the electrical wires as follows. Connect the Black wire from

the fixture to the black house (hot) Wire. Connect the white wire

from the fixture to the white (neutral) house wire. Make sure all wire

nuts are secured. You may wrap the connections with electrical

tape. If your outlet box has a ground wires (green or bare copper)

connect fixture’s ground wire to it. Otherwise attach the bare copper

fixture wire to the green ground screw on the mounting plate.

2. Tuck the wire connections neatly into the wall junction box.

Your installation is now complete. Return power to the junction

box and test the fixture.

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black(Hot)

FIXTURE

WIRES

White or

Ribbed

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

White

(Neutral)

HOUSE

WIRES

Green or Bare

Copper(Ground)

Thank you for purchasing a LIVEX product.

Need assistance with parts or assembly? Please call customer service at: 800-761-8056

Or visit us on-line at: WWW.LIVEXLIGHTING.COM

FIG.2

FIG.1