Instructions / Assembly

ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed.
However, the installation instructions do apply to this product.
10361 10363 10365
 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove old fixture and all
hardware from Junction Box. Carefully unpack your new fixture and lay out
all the parts on a clear area. Take care not to lose any small parts
necessary for installation.
2. Thread the two mounting screws about 1/4” into the pre-drilled holes in the
mounting plate, spaced about the same distance apart as the holes in the
fixture back plate. Attach the mounting plate to the junction box using two
junction box screws as shown. The side of the single bar marked
“GND” must face out. The junction box is not included.
3. Guide fixture wires through hole in center of mounting plate. Follow wiring
instructions carefully (see fig.2).
4.
Attach the back plate of the lamp body(B) onto the junction box, aligning the
back plate’s hole with mounting screw and lock it securely with the ball
nuts(C).
5. Install the light bulbs(Not included) in accordance with the fixture’s
specifications. DO NOT EXCEED THE MAXIMUM WATTAGE RATING!
6. Attach the glass shade(A) insert to the lamp holder, by turn it clockwise
until tight.
CONNECTING THE WIRES (Fig.2)
1. Connect the electrical wires as follows. Connect the Black wire from the
fixture to the black house (hot) Wire. Connect the white wire from the
fixture to the white (neutral) house wire. Make sure all wire nuts are
secured. You may wrap the connections with electrical tape. If your outlet
box has a ground wires (green or bare copper) connect fixture’s ground
wire to it. Otherwise attach the bare copper fixture wire to the green ground
screw on the mounting plate.
2. Tuck the wire connections neatly into the wall junction box.
Your installation is now complete. Return power to the junction
box and test the fixture.
Mountingplate
Mounting
GroundWire
JunctionBox
(Notincluded)
wire
screw
Fixture
B
C
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black(Hot)
FIXTURE
WIRES
White or
Ribbed
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green or Bare
Copper(Ground)
Thank you for purchasing a LIVEX product.
Need assistance with parts or assembly? Please call customer service at: 800-761-8056
Or visit us online at: WWW.LIVEXLIGHTING.COM
©COPYRIGHT ALL RIGHTS RESERVED.LIVEX LIGHTING,INC. DOC20180110361
FIG.2
FIG.1