Operating Guide

ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed.
However, the installation instructions do apply to this product.
1331 1332 1333 1334 1335
 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove old fixture and all
hardware from Junction Box.
2. Carefully unpack your new fixture and lay out all the parts on a clear area.
Take care not to lose any small parts necessary for installation.
3. Thread the two mounting screws into the pre-drilled holes in the mounting
plate, spaced about the same distance apart as the holes in the fixture back
plate. Attach the mounting plate to the junction box using two junction box
screws as shown. The side of the mounting plate marked “GND” must face
out. The junction box is not included.
4. Guide fixture wires through hole in center of mounting plate.
5. Follow wiring instructions carefully (see fig.2).
6. Place the lamp body(D) onto the mounting plate, aligning the holes with
mounting screws, then lock it securely with the ball nut(E).
7. Raise the glass shade (C) and cover (B) to the socket holder, lock it securely
with ring (A) until snug.
8. Install the light bulbs (not included) in accordance with the fixture’s
specifications. NOTE: DO NOT EXCEED THE MAXIMUM WATTAGE
RATING!
CONNECTING THE WIRES (Fig.2)
1. Connect the electrical wires as follows. Connect the Black wire from the
fixture to the black house (hot) Wire. Connect the white wire from the fixture
to the white (neutral) house wire. Make sure all wire nuts are secured. You
may wrap the connections with electrical tape. If your outlet box has a
ground wires (green or bare copper) connect fixture’s ground wire to it.
Otherwise attach the bare copper fixture wire to the green ground screw on
the mounting plate.
2. Tuck the wire connections neatly into the wall junction box.
Your installation is now complete. Return power to the junction
box and test the fixture.
D
C
B
A
E
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black(Hot)
FIXTURE
WIRES
White or
Ribbed
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green or Bare
Copper(Ground)
Thank you for purchasing a LIVEX product.
Need assistance with parts or assembly? Please call customer service at: 800-761-8056
Or visit us on-line at: WWW.LIVEXLIGHTING.COM
©COPYRIGHT ALL RIGHTS RESERVED.LIVEX LIGHTING,INC. DOC20160401331
FIG.2
FIG.1
(
Not included
)