Installation Guide

ManualsBrandsLivex Lighting ManualsSemi-Flush Mount LightsEssex 6.25-in W Polished Brass Alabaster Glass Semi-Flush Mount Light

ASSEMBLING & INSTALLATION INSTRUCTIONS

The drawing shown may not exactly match the product enclosed.

However, the installation instructions do apply to this product.

1350

 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.

ASSEMBLING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker box. Remove old

fixture and all hardware from Junction Box.

2. Carefully unpack your new fixture and lay out all the parts on a

clear area. Take care not to lose any small parts necessary for

installation.

3. Thread the two mounting screws into the pre-drilled holes in

the Mounting plate spaced the same distance apart as the

holes in the canopy (A).

4. Attach the Mounting plate to the Junction Box with the two

Junction Box Screws as shown. The side of the Mounting plate

marked "GND" must face out. The junction box is not included.

5. While holding the canopy (A) assembly towards the ceiling,

connect the electrical wires as Shown in Fig.2, making sure

that all wire nuts are secured. You may have to wrap the

connections with electrical tape. If your outlet has a ground

wire (green or bare copper), connect the fixture ground wire to

it. Otherwise connect fixture’s ground wire directly to the

Mounting strap with the green screw provided. After wires are

connected, tuck them carefully inside the Junction Box.

6. Attach the canopy (A) to the junction box, aligning screws on

mounting plate with mounting holes in canopy and lock it

securely with the ball nut (B).

7. Attach the glass shade(C) to bottom of the lamp holder, then

lock it securely with ring(D) until sung.

8. Install the light bulb(Not included) in accordance with the

fixture’s specifications. NOTE: DO NOT EXCEED THE

SPECIFIED WATTAGE!

Your installation is now complete. Return power to the

junction box and test the fixture.

GreenScrew

(GND)

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black(Hot)

FIXTURE

WIRES

White or

Ribbed

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

White

(Neutral)

HOUSE

WIRES

Green or Bare

Copper(Ground)

Thank you for purchasing a LIVEX product.

Need assistance with parts or assembly? Please call customer service at: 800-761-8056

Or visit us on-line at: WWW.LIVEXLIGHTING.COM

FIG.2

FIG.1

Summary of content (1 pages)

PAGE 1
ASSEMBLING & INSTALLATION INSTRUCTIONS The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product. FIG.1 1350 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER. ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR. ASSEMBLING THE FIXTURE (Fig.1) 1. Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box. 2. Carefully unpack your new fixture and lay out all the parts on a clear area.