Installation Sheet

ManualsBrandsLivex Lighting ManualsBathroom LightsBirmingham 3 Light 24" Wide Bathroom Vanity Light

ASSEMBLING & INSTALLATION INSTRUCTIONS

The drawing shown may not exactly match the product enclosed.

However, the installation instructions do apply to this product.

17073 17075 17076

 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.

ASSEMBLING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker box. Remove old fixture and all

hardware from Junction Box.

2. Carefully unpack your new fixture and lay out all the parts on a clear area.

Take care not to lose any small parts necessary for installation.

3. Drilling two holes in the wall, distance and the same distance from the

keyhole of mounting plate, then loaded plastic anchors(A). Attach the

mounting plate(B) to the wall, aligning the plastic anchors(A) and junction

box, lock it securely with the two wood screws(D) and the two box

screws(E). The side of the back plate marked “GND” must face out. The

junction box is not included.

4. Guide fixture wires through hole in center of back plate.

5. Follow wiring instructions carefully (see fig.2).

6. Place the lamp body(H) onto the mounting plate so that the studs(C)

protrude through the cover plate holes, then tighten it with the ball nut(I).

7. Raise the glass shade(G) to the lamp holder and using the check ring(F)

by turning it clockwise until tight.

8. Install the light bulbs(Not included) in accordance with the fixture’s

specifications. NOTE: DO NOT EXCEED THE MAXIMUM WATTAGE

RATING!

CONNECTING THE WIRES (Fig.2)

1. Connect the electrical wires as follows. Connect the Black wire from the

fixture to the black house (hot) Wire. Connect the white wire from the fixture

to the white (neutral) house wire. Make sure all wire nuts are secured. You

may wrap the connections with electrical tape. If your outlet box has a

ground wires (green or bare copper) connect fixture’s ground wire to it.

Otherwise attach the bare copper fixture wire to the green ground screw on

the mounting plate.

2. Tuck the wire connections neatly into the wall junction box.

Your installation is now complete Return power to the junction box and

test the fixture.

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black(Hot)

FIXTURE

WIRES

White or

Ribbed

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

White

(Neutral)

HOUSE

WIRES

Green or Bare

Copper(Ground)

Thank you for purchasing a LIVEX product.

Need assistance with parts or assembly? Please call customer service at: 800-761-8056

Or visit us on-line at: WWW.LIVEXLIGHTING.COM

FIG.2

FIG.1