Installation Sheet

ManualsBrandsLivex Lighting ManualsComplete Post LightsNyack 6 light black outdoor post light

ASSEMBLING & INSTALLATION INSTRUCTIONS

The drawing shown may not exactly match the product enclosed.

However, the installation instructions do apply to this product.

20599

 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.

ASSEMBLING THE FIXTURE (Fig.1).

*Shut off the power at the circuit breaker and remove old fixture, including the

old small hardware.

1. Carefully unpack new fixture and lay all the parts on a clear surface. Take care not

to lose any small parts necessary for installation.

2. Place the candle sleeve(B) insert to the lamp holder. Install the light bulbs(not

included) in accordance with the fixture specifications. NOTE: DO NOT EXCEED

THE SPECIFIED WATTAGE!

3. Screw the pole(C),(D),(E),(F),(G) together tightly, follow wiring instructions

carefully (see fig.2).

4. Put the assembled lamp onto the concrete base and lock it with the mounting

knob(H).

A. The depth of the base will depend on local soil conditions and frost line. The

width of the base should be 380mm in order to hold the anchor bolts on it.

B. Take the four bolts(I) and run a hex nut(J) fully down each part of the threaded

section. Insert the bolt(I) to the template(K) and secure with the

second hex nuts.

C. Mix and pour the concrete into the former until it reaches the top. Push the

assembly into concrete until the plate are 0.25 inches above concrete.

Leaving 2.5 inches of the thread above the concrete.

D. It is important to level the template before the concrete sets.

5. Secure the poles using the machine screws on side.

CONNECTING THE WIRES (Fig.2)

*Feed the fixture wires through the pole(C),(D),(E),(F),(G).

1. Take the black wire(hot) from the outlet box and the black wire of fixture and twist

bare ends together. Twist wire connector onto end of wire until snug.

2. Repeat same process with white wire(neutral) from outlet box and white wire of

fixture. NOTE: Twist wires together in the same direction you twist the wire

connector onto wires.

3. If your outlet box has a grounding wire (green or bare copper), attach this wire and

the bare copper wire from the fixture together as step 1. If junction box has no

ground wire, attach the bare copper fixture wire to the green ground screw in the

bottom of the pole(G).

4. Tuck the wire connections neatly into the pole. Take the fixture body(A) mount

onto the pole(C) .

Your installation is now complete. Return power to the junction box and

test the fixture.

Machine

screw

Machine

screw

FIXTURE

WIRES

Black

Smooth

HOUSE

WIRES

Black(Hot)

FIXTURE

WIRES

White

Ribbed

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

White

(Neutral)

HOUSE

WIRES

Green or Bare

Copper(Ground)

Fig.2

Thank you for purchasing a LIVEX product.

Need assistance with parts or assembly? Please call customer service at: 800-761-8056

Or visit us on-line at: WWW.LIVEXLIGHTING.COM

Fig.1