Installation Sheet

ManualsBrandsLivex Lighting ManualsLightingProvidence 3-Light Outdoor Black Incandescent Pendant

ASSEMBLING & INSTALLATION INSTRUCTIONS

The drawing shown may not exactly match the product enclosed.

However, the installation instructions do apply to this product.

2265 2365 2355 2357 2255

 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.

ASSEMBLING THE FIXTURE (Fig.2)

1. Put the candle sleeve over the lamp holder.

2. Install the light bulbs (Not included) in accordance with the fixture specifications.

NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!

HANGING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker and remove old fixture from ceiling,

including the old single bar.

2. Carefully unpack new fixture and lay all the parts on a clear surface.

3. Thread nipple (C) into loop (F) until snug.

4. Thread other end of nipple (C) with loop attached into single bar (D) until snug.

5. Place lock washer (B) over end of nipple protruding through single bar and thread

hex nut (A) onto nipple until tight.

6. Take this single bar assembly and mount to ceiling junction box with junction box

screws (E). Tighten screws securely with screwdriver.

7. Using proper chain pliers to open one end link of the chain provided and connect

to the fixture loop. Close the link.

8. By measuring, determine correct number of links needed for proper hanging

height. Using proper chain pliers disconnect and discard remaining chain.

9. Lace the fixture wires through the chain.

10. Slip loop collar (H) over the chain, then do the same with the canopy (G).

11. Open the other end link of the chain and hang the fixture on the loop at the

ceiling . Close the link.

12. Feed the fixture wires through the loop (F) and nipple (C) and pull until taut.

CONNECTING THE WIRES (Fig.3)

1. Take the black wire from the ceiling junction box and the smooth wire leg from the

fixture and twist bare ends together. Twist wire connector onto end of wire until

snug.

2. Repeat same process with white junction box wire and ribbed wire leg of fixture

wire. NOTE: Twist wires together in the same direction you twist the wire

connector onto wires.

3. If your junction box has a grounding wire (green or bare copper), attach this wire

and the bare copper wire from the fixture together as step 1.If junction box has no

ground wire, attach the bare copper fixture wire to the green ground screw on the

crossbar.

4. Tuck these wire connections neatly into the ceiling outlet box and then raise the

canopy (G) all the way to the ceiling. Raise the loop (H) and thread onto ceiling

loop protruding through canopy.

Your installation is now complete. Return power to the junction box and test the

fixture.

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black(Hot)

FIXTURE

WIRES

White or

Ribbed

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

White

(Neutral)

HOUSE

WIRES

Green or Bare

Copper(Ground)

Thank you for purchasing a LIVEX product.

Need assistance with parts or assembly? Please call customer service at: 800-761-8056

Or visit us on-line at: WWW.LIVEXLIGHTING.COM

FIG.3

FIG.1FIG.2