Installation Manual

ASSEMBLING & INSTALLATION INSTRUCTIONS PRODUCT# 2181 2281 2381
2386 2162 2165 2168 2172 OUTDOOR WALL MOUNT LIGHT FIXTURE
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
MOUNTING THE FIXTURE
Installation (see fig.1)
1. Shut off the power at the circuit breaker and remove old
fixture, including the cross bar.
2. Carefully unpack new fixture and lay all the parts on a clear
surface. Take care not to lose any small parts necessary for
installation.
3. Attach the mounting screw part way into the side hole of the
crook cross bar, then lock it securely with hex nut until
becoming. Attach the cross bar to the junction box using two
box screws. The side of the cross bar marked “GND” must
face out.
4. Follow wiring instructions carefully (see fig.2)
5. Using the end of arm(A) hook the lamp body's loop, aligning
the end hole of the arm(A) with the top hole of back plate,
lock it securely with screw(E) and hex nut. Put the candle
sleeve(D) over the lamp holder.
6. Attach the back plate of the lamp body(B) onto the junction
box, aligning screws on cross bar with mounting holes and
lock it securely with the ball nuts(C).
7. Install the light bulbs in accordance with the fixture’s
specifications. DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!
8. With silicone caulking compound, caulk completely
around where back of cover meets with the wall surface
to prevent water from seeping into outlet box.
Wiring (see fig.2)
1. Connect the electrical wires as follows. Connect the
black wire from the fixture to the black house (hot)
Wire. Connect the white wire from the fixture to the
white (neutral) house wire. Make sure all wire nuts are
secured. You may wrap the connections with electrical
tape. If your outlet box has a ground wire (green or bare
copper) connect fixture’s ground wire to it. Otherwise
attach the bare copper fixture wire to the green ground
screw on the cross bar.
2.Tuck the wire connections neatly into the wall junction
box.
Fig.1
Fig.2
White or
HOUSE
Black
WIRES
(Hot)
Smooth
FIXTURE
WIRES
Black or
Ribbed
WIRES
FIXTURE
Bare Copper(Ground)
FIXTURE
WIRES
Copper
(Ground)
HOUSE
(Neutral)
WIRES
White
Bare
Green or
WIRES
HOUSE