Instructions / Assembly

ASSEMBLING & INSTALLATION INSTRUCTIONS PRODUCT# 2611
For Ceiling Mount Fixtures
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
MOUNTING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove old
fixture and all hardware from Junction Box.
2. Carefully unpack your new fixture and lay out all the parts
on a clear area. Take care not to lose any small parts
necessary for installation.
3. Attach the mounting screw part way into the side hole of the
crook cross bar, then lock it securely with hex nut until
becoming.
4. Attach the cross bar to the Junction Box with the two Box
screws as shown. The side of the cross bar marked "GND"
must face out. The junction box is not included.
5. While holding the lamp body towards the ceiling, connect
the electrical wires as Shown in Fig.2, making sure that all
wire nuts are secured. You may have to wrap the
connections with electrical tape. If your outlet has a
ground wire (green or bare copper), connect the fixture
ground wire to it. Otherwise connect fixture’s ground wire
directly to the cross bar with the green screw provided.
After wires are connected, tuck them carefully inside the
Junction Box.
6. Put the lamp body onto the junction box, aligning screws on
crook cross bar with mounting holes in lamp body and lock
it securely with the ball nut.
7. Install the light bulbs in accordance with the fixture’s
specifications. NOTE: DO NOT EXCEED THE
SPECIFIED WATTAGE.
Your installation is now complete. Return power to the
junction box and test the fixture.
Fig.1
Lamp Bod
y
Fig.2
MIN 90℃ SUPPLY CONDUCTORS
DOC20141202611
White or
HOUSE
Black
WIRES
(Hot)
Smooth
FIXTURE
WIRES
Black or
Ribbed
WIRES
FIXTURE
Bare Copper(Ground)
FIXTURE
WIRES
Copper
(Ground)
HOUSE
(Neutral)
WIRES
White
Bare
Green or
WIRES
HOUSE