Instructions / Assembly

ManualsBrandsLivex Lighting ManualsLightingNewburyport 1-Light Antique Brass Outdoor Wall Mount Lantern

ASSEMBLING & INSTALLATION INSTRUCTIONS

The drawing shown may not exactly match the product enclosed.

However, the installation instructions do apply to this product.

2222 2223 26900 26901 26904 27000 27001 27004

 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.

ASSEMBLING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker and remove old fixture,

including the single bar. Carefully unpack your new fixture and lay

out all the parts on a clear area. Take care not to lose any small

parts necessary for installation.

2. Thread the pipe thread part way into the center hole of the single bar

and secure with the hex nut.

3. Attach the single bar to the junction box using two box screws as

shown. The side of the single bar marked “GND” must face out. The

junction box is not included.

4. Follow wiring instructions carefully (see fig.2)

5. Using the end of arm(C) hook the lamp body's loop, aligning the

other end hole of the arm(C) with the top hole of back plate, lock it

securely with screw and hex nut. Attach the lamp body(A) onto the

junction box, aligning the back plate mounting hole with the pipe

thread, then tighten it with the ball nut (B).

6. Install the light bulb(Not included) in accordance with the fixture’s

specifications. NOTE: DO NOT EXCEED THE MAXIMUM

WATTAGE RATING!

7. With silicone caulking compound, caulk completely around

where back of cover meets with the wall surface to prevent

water from seeping into junction box.

CONNECTING THE WIRES (Fig.2)

1. Connect the electrical wires as follows. Connect the Black wire from

the fixture to the black house (hot) Wire. Connect the white wire from

the fixture to the white (neutral) house wire. Make sure all wire nuts

are secured. You may wrap the connections with electrical tape. If

your outlet box has a ground wires (green or bare copper) connect

fixture’s ground wire to it. Otherwise attach the bare copper fixture

wire to the green ground screw on the mounting plate.

2. Tuck the wire connections neatly into the wall junction box.

Your installation is now complete. Return power to the junction

box and test the fixture.

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black(Hot)

FIXTURE

WIRES

White or

Ribbed

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

White

(Neutral)

HOUSE

WIRES

Green or Bare

Copper(Ground)

Thank you for purchasing a LIVEX product.

Need assistance with parts or assembly? Please call customer service at: 800-761-8056

Or visit us on-line at: WWW.LIVEXLIGHTING.COM

FIG.2

FIG.1