Installation Sheet

ManualsBrandsLivex Lighting ManualsLamps1-Light Antique Brass Swing Arm Light

ASSEMBLING & INSTALLATION INSTRUCTIONS

The drawing shown may not exactly match the product enclosed.

However, the installation instructions do apply to this product.

40030 40038 40039 40034 40036 40037

 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.

ASSEMBLING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker box. Remove old fixture and all

hardware from Junction Box. Carefully unpack your new fixture and lay out all

the parts on a clear area. Take care not to lose any small parts necessary for

installation.

2. Drilling four holes in the wall, distance and the same distance from the keyhole

of back plate(F), then loaded plastic anchors. Mount the back plate(F) to the

wall with the plastic anchors(E) and the wood screw(G). The side of the

mounting plate marked “GND” must face out. The junction box is not

included.

3. Follow wiring instructions carefully (see fig.2◆ ).

4. If you not need cord assembly of the fixture lamp, please pause and take out

fixture wires nuts of the back plate, then follow wiring instructions carefully. (see

fig.2 and fig.1.1)

5. Attach the fixture body (C) onto the back plate, lock it securely with the

mounting screw(D). Mount the plastic anchors and inside cord slot(H,1PC) to

the wall, lock them with the wood screw. Slide the fixture wires into the inside

cord slot, then attach the outside cord slot(I,2PCS) snap into the inside cord

slot.

6. Raise the shade(A) to the lamp holder，then lock it securely with check ring (B)

until tight.

7. Install the light bulb(not included) in accordance with the fixture’s specifications.

NOTE: DO NOT EXCEED THE MAXIMUM WATTAGE RATING!

CONNECTING THE WIRES (Fig.2)

1. Connect the electrical wires as follows. Connect the Black wire from the fixture

to the black house (hot) Wire. Connect the white wire from the fixture to the

white (neutral) house wire. Make sure all wire nuts are secured. You may

wrap the connections with electrical tape. If your junction box has a ground

wires (green or bare copper) connect fixture’s ground wire to it.

 Otherwise attach the bare copper fixture wire to the green ground

screw on the mounting plate.

2. Tuck the wire connections neatly into the wall junction box.

Your installation is now complete. Return power to the junction

box and test the fixture.

40030

40038

40039

40034

40036

40037

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black(Hot)

FIXTURE

WIRES

White or

Ribbed

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

White

(Neutral)

HOUSE

WIRES

Green or Bare

Copper(Ground)

Thank you for purchasing a LIVEX product.

Need assistance with parts or assembly? Please call customer service at: 800-761-8056

Or visit us on-line at: WWW.LIVEXLIGHTING.COM

FIG.2

FIG.1