Installation Guide

ManualsBrandsLivex Lighting ManualsCeiling LightsHillcrest Brushed Nickel Transitional Incandescent Semi-Flush Mount Light

ASSEMBLING & INSTALLATION INSTRUCTIONS

The drawing shown may not exactly match the product enclosed.

However, the installation instructions do apply to this product.

40474

 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.

MOUNTING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker box. Remove old fixture and

all hardware from Junction Box.

2. Carefully unpack your new fixture and lay out all the parts on a clear

area. Take care not to lose any small parts necessary for installation.

3. Thread the pipe screw part way into the center hole of the single bar

and secure with hex nut.

4. Attach the single bar to the junction box using two box screws as

shown. The side of the single bar marked “GND” must face

out . The junction box is not included.

5. While holding the plate(A) assembly towards the ceiling, connect

the electrical wires as Shown in Fig.2, making sure that all wire

nuts are secured. You may have to wrap the connections with

electrical tape. If your outlet has a ground wire (green or bare

copper), connect the fixture ground wire to it. Otherwise connect

fixture’s ground wire directly to the Mounting strap with the green

screw provided. After wires are connected, tuck them carefully

inside the Junction Box.

6. Raise plate(A) onto the junction box, aligning pipe screw on single

bar with center hole in plate and lock it securely with the ball nut(B).

7. Raise the glass(C) insert to the cover of lamp holder, by turning it

clockwise until tight.

8. Install the light bulbs(not included) in accordance with the fixture’s

specifications. NOTE: DO NOT EXCEED THE SPECIFIED

WATTAGE!

Your installation is now complete. Return power to the

junction box and test the fixture.

WHITE

HOUSE

Black

WIRES

(

Hot

)

FIXTURE

WIRES

BLACK

WIRES

FIXTURE

Bare

FIXTURE

WIRES

(Ground)

HOUSE

(

Neutral

)

WIRES

White

Green or

WIRES

HOUSE

Copper(Ground)

GREEN

Thread

Thank you for purchasing a LIVEX product.

Need assistance with parts or assembly? Please call customer service at: 800-761-8056

Or visit us online at: WWW.LIVEXLIGHTING.COM

FIG.3

FIG.1

Summary of content (1 pages)

PAGE 1
ASSEMBLING & INSTALLATION INSTRUCTIONS The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product. FIG.1 40474 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER. ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR. MOUNTING THE FIXTURE (Fig.1) 1. Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box. 2. Carefully unpack your new fixture and lay out all the parts on a clear area.