Installation Guide

ASSEMBLING & INSTALLATION INSTRUCTIONS PRODUCT# 4666 4668
For Chain Hang OR Ceiling Mount
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
Fig.1
ASSEMBLING THE FIXTURE (Fig.2).
1. Attach the arm(D) at both ends pipe thread insert the side hole of the
fixture body(E), then lock it securely with the spring washer and hex
nut(C & F).
2. Attach the c
over(B) to the top pipe thread of the fixture body(E), lock
it securely with the loop(A) until tight. Raise the cover(G) to the
bottom pipe thread of the fixture body(E), lock it securely
with the
finial(H).
3. Install the light bulbs in accordance with the fixture specifications
NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!
HANGING THE FIXTURE (Fig.1)
1. Sh
ut off the power at the circuit breaker and remove old fixture
from ceiling, including the old single bar.
2. Carefully unpack new fixture and lay all the parts
on a clear
surface.
3. Th
read the two studs into the pre-drilled holes in the Moun
ting
plate s
paced the same distance apart as the holes in the
canopy .Attach the Mounting plate to the Junction Box with the
t
wo Junction Box Screws as shown. The side of the Mounting
plate marked "GND" must face to
out.
4. Using proper chain pliers to open one end link of the chain
provided and connect to the fixture loop. Close the link.
5. By measuring, determine correct number of links needed for
proper hanging height. Using proper chain pliers disconnect
and
di
scard remaining chain.
6. Lace the fixture wires through the chai
n.
7. O
pen the other end link of the chain and hang the fixture on
the
loop at the
ceiling. Close the li
nk.
8. Feed
the fixture wires through the loop of the canopy and pull un
til
tau
t
.
9. Slide canopy up flush to ceiling, lock it securely with ball nut.
CONNECTING THE WIRES (Fig.3)
1. Take the black wire from the ceiling junction box and the smoot
h
wire leg
from the fixture and twist bare ends together. Twis
t wire
connector onto end of wire until snug.
2.
Repeat same process with white junction box wire and ribbed wire
leg of fixture wire. NOTE: Twist wires together in the same
direction you twist the wire connector onto
wires.
3.
If your junction box has a grounding wire (green or bare copper),
attach this wire and the bare copper wire from the fixture together
as step 1.If junction box has no ground wire, attach the bare copper
fixture wire to the green ground screw on the single bar.
4. Tuck these wire connections neatly into the ceiling outlet box and
then raise the canopy all the way to the ceiling.
Lock it securely
with ball nut.
Your installation is now complete. Return power to the junction
box and test the fixture.
Fig.2
$
%
&
'
(
)
*
+
Fig.3
:KLWHRU
+286(
%ODFN
:,5(6
+RW
6PRRWK
),;785(
:,5(6
%ODFNRU
5LEEHG
:,5(6
),;785(
%DUH&RSSHU*URXQG
),;785(
:,5(6
&RSSHU
*URXQG
+286(
1HXWUDO
:,5(6
:KLWH
%DUH
*UHHQRU
:,5(6
+286(
DOC20141204666
(Not included)