Operating Guide

ManualsBrandsLivex Lighting ManualsPendant Lighting475004

ASSEMBLING & INSTALLATION INSTRUCTIONS

The drawing shown may not exactly match the product enclosed.

However, the installation instructions do apply to this product.

4750 4770

 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.

ASSEMBLING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker box. Remove old fixture and all

hardware from Junction Box. The junction box is not include.

2. Carefully unpack your new fixture and lay out all the parts on a clear area.

Take care not to lose any small parts necessary for installation.

3. Slide the electrical wires (lamp body ‘C’) through the tubes(B)/(A) and canopy.

4. Raise the tube (B) to top screw pipe of lamp body (C), raise the tube (A),tube

(B) and canopy to the screw pipe in order , then by turning it clockwise until

tight.

5. Raise the glass shade (D) to the lamp holder, lock it securely with the check

ring(E).

6. Install the light bulb (Not included) in accordance with the fixture

specifications. NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!

7. Thread the two mounting screws into the pre-drilled holes in the single bar

spaced the same distance apart as the holes in the canopy.

8. Attach the single bar to the Junction Box with the two Junction Box screws as

shown. The side of the single bar marked "GND" must face to out. The

junction box is not included.

9. While holding the fixture lamp towards the ceiling , connect the electrical wires

as Shown in Fig.2, making sure that all wire nuts are secured. You may have

to wrap the connections with electrical tape. If your outlet has a ground wire

(green or bare copper), connect the fixture ground wire to it. Otherwise

connect fixture’s ground wire directly to the Mounting plate with the green

screw provided. After wires are connected, tuck them carefully inside the

Junction Box.

10. Raise the canopy on to the Junction box, aligning screws on single bar with

mounting holes in canopy and lock it securely with the knurled nuts.

Your installation is now complete. Return power to the junction

box and test the fixture.

FIG.1

Green

(GND)

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black(Hot)

FIXTURE

WIRES

White or

Ribbed

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

White

(Neutral)

HOUSE

WIRES

Green or Bare

Copper(Ground)

Thank you for purchasing a LIVEX product.

Need assistance with parts or assembly? Please call customer service at: 800-761-8056

Or visit us online at: WWW.LIVEXLIGHTING.COM

FIG.2