Instructions / Assembly

ManualsBrandsLivex Lighting ManualsLightingUptown 8-Light Antique Brass Sputnik Large Foyer Chandelier with Acid Etched Rods

ASSEMBLING & INSTALLATION INSTRUCTIONS

The drawing shown may not exactly match the product enclosed.

However, the installation instructions do apply to this product.

41258 48828

 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.

ASSEMBLING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker box. Remove old fixture and all

hardware from Junction Box.

2. Carefully unpack your new fixture and lay out all the parts on a clear area.

Take care not to lose any small parts necessary for installation.

3. Raise the end of pipe thread into coupling, lock it with the hex nut until tight.

Raise the other end of pipe thread into single bar (D), place lock washer over

the end of thread protruding through single bar and lock it securely with the

hex nut.

4. Slide the electrical wires through the tube(M)/(L)/(K)/(J)/(I)/(G)/ring(H)/

canopy(F) and assembled single bar(D). By measuring, determine correct

tube length needed for proper hanging height.

5. Raise the tube(M) to the center pipe thread of the lamp body(N), raise the

other tubes and assembled single bar(D) to the screw pipe nipple in order,

then by turning it clockwise until tight.

6. While holding the assembled single bar(D) of fixture body to the ceiling

junction box with junction box screws (E) as shown, tighten screws securely

with screwdriver. The side of the single bar marked "GND" must face out. The

junction box is not included.

7. Connect the electrical wires as Shown in Fig.2, making sure that all wire nuts

are secured. You may have to wrap the connections with electrical tape. If

your outlet has a ground wire (green or bare copper), connect the fixture

ground wire to it. Otherwise connect fixture’s ground wire directly to the single

bar with the green screw provided. After wires are connected, tuck them

carefully inside the Junction Box.

8. Slide the canopy(F) onto the Junction box, lock it securely with the ring(H) until

tight.

9. Install the light bulbs(Not included) in accordance with the fixture

specifications. NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!

10. Raise the end screw of the crystal stick(A) insert to the top screw hole of the

lamp body(N), by turn it clockwise until tight. Raise the end screw of the

crystal stick(B) insert to the bottom adjacent screw hole of the crystal stick(A),

by turn it clockwise until tight. Assembled using the same method the others

crystal sticks(order: A, B, A, B, A……). Note: the crystal stick(C) only one,

you must mounted to the bottom center screw of the lamp body(N).

Your installation is now complete. Return power to the junction box and

test the fixture.

A:8PCS

A:32PCS

B:36PCS

C:1PC

Coupling

D0.6" x 6" x 1PC

D0.6" x 12" x 1PC

D0.6" x 18" x 4PCS

41258

B:12PCS

WHITE

HOUSE

Black

WIRES

(Hot)

FIXTURE

WIRES

BLACK

WIRES

FIXTURE

Bare

FIXTURE

WIRES

(Ground)

HOUSE

(Neutral)

WIRES

White

Green or

WIRES

HOUSE

Copper(Ground)

GREEN

Thread

Thank you for purchasing a LIVEX product.

Need assistance with parts or assembly? Please call customer service at: 800-761-8056

Or visit us online at: WWW.LIVEXLIGHTING.COM

FIG.2

FIG.1