Instructions / Assembly

ManualsBrandsLivex Lighting ManualsLightingPierson 13 in. Brushed Nickel ADA Sconce with Hand Crafted Off-White Fabric Shade

ASSEMBLING & INSTALLATION INSTRUCTIONS

The drawing shown may not exactly match the product enclosed.

However, the installation instructions do apply to this product.

51101 51103 52131 52132 51104

50990 50991 50994 50995

 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.

ASSEMBLING THE FIXTURE (Fig.1)

1. Disconnect power at main electrical panel before installation.

Remove old fixture and all hardware from Junction Box.

2. Attach the mounting plate to the junction box using two junction box

screws as shown. The side of the mounting plate marked “GND” must

face out. The junction box is not included.

3. Guide fixture wires through hole in center of mounting plate.

4. Follow wiring instructions carefully (see fig.2)

5. Attach the shade(C) insert the lamp holder, lock it securely with the

check ring(D).

6. Install the light bulbs(Not included) in accordance with the fixture’s

specifications. NOTE: DO NOT EXCEED THE MAXIMUM

WATTAGE RATING!

7. Attach the lamp body (B) onto the mounting plate, aligning the back

plate holes with screw hole of the mounting plate on side, then lock it

securely with mounting screw(A).

CONNECTING THE WIRES (Fig.2)

1. Connect the electrical wires as follows. Connect the Black wire

from the fixture to the black house (hot) Wire. Connect the

white wire from the fixture to the white (neutral) house wire.

Make sure all wire nuts are secured. You may wrap the

connections with electrical tape. If your outlet box has a ground

wire (green or bare copper) connect fixture’s ground wire to it.

Otherwise attach the bare copper fixture wire to the green

ground screw on the mounting plate.

2.Tuck the wire connections neatly into the wall junction box.

Your installation is now complete Return power to the junction

box and test the fixture.

Your installation is now complete. Return power to the junction box and

test the fixture.

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black(Hot)

FIXTURE

WIRES

White or

Ribbed

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

White

(Neutral)

HOUSE

WIRES

Green or Bare

Copper(Ground)

Thank you for purchasing a LIVEX product.

Need assistance with parts or assembly? Please call customer service at: 800-761-8056

Or visit us on-line at: WWW.LIVEXLIGHTING.COM

FIG.2

FIG.1

Summary of content (1 pages)

PAGE 1
ASSEMBLING & INSTALLATION INSTRUCTIONS The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product. FIG.1 51101 51103 52131 52132 51104 50990 50991 50994 50995 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER. ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR. ASSEMBLING THE FIXTURE (Fig.1) 1. Disconnect power at main electrical panel before installation. Remove old fixture and all hardware from Junction Box. 2.