Installation Guide

ASSEMBLING & INSTALLATION INSTRUCTIONS PRODUCT#51074, 51075
CEILING MOUNT FIXTURE
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
ASSEMBLING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove old
fixture and all hardware from Junction Box.
2. Carefully unpack your new fixture and lay out all the parts
on a clear area. Take care not to lose any small parts
necessary for installation.
3. Thread the pipe screw part way into the center hole of the
single bar and secure with hex nut.
4. Attach the single bar to the junction box using two box
screws. The side of the single bar marked “GND” must
face out. The junction box is not included.
5. Attach the shade(E) into the shade frame(F), raise the glass
(C) , plastic shim (D) and shade frame(F) to the bottom of
the lamp body, aligning the hole with pipe nipple and screw
it with the finial (G).
6. Install the light bulbs in accordance with the fixture
specifications NOTE: DO NOT EXCEED THE
SPECIFIED WATTAGE!
7. While holding the shade assembly towards the ceiling,
connect the electrical wires as Shown in Fig.2, making sure
that all wire nuts are secured. You may have to wrap the
connections with electrical tape. If your outlet has a ground
wire (green or bare copper), connect the fixture ground wire
to it. Otherwise connect fixture’s ground wire directly to the
mounting plate with the green screw provided. After wires
are connected, tuck them carefully inside the Junction Box.
8. Raise the shade assembly onto the junction box, aligning
screws on single bar with mounting holes in lamp body(B)
and lock it securely with the ball nut (A).
Your installation is now complete. Return power to the
junction box and test the fixture.
Fig.1
Fig.2
White or
HOUSE
Black
WIRES
(Hot)
Smooth
FIXTURE
WIRES
Black or
Ribbed
WIRES
FIXTURE
Bare Copper
FIXTURE
WIRES
Copper
(Ground)
HOUSE
(Neutral)
WIRES
White
Bare
Green or
WIRES
HOUSE
(Ground)
Page 1 of 1 DOC20141151074