Installation Guide

ManualsBrandsLivex Lighting ManualsCeiling LightsChesterfield/Pennington 5-Light Brushed Nickel Flushmount

ASSEMBLING ＆ INSTALLATION INSTRUCTIONS PRODUCT#51864 51866

For Flush Mount Ceiling Fixtures

ARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .

AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.

MOUNTING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker box.

Remove the old fixture and all hardware from

junction box.

2. Carefully unpack your new fixture and lay out all

the parts on a clear area. Take care not to lose any

small parts necessary for installation.

3. Attach the mounting plate (A) to the junction box

using screws (B). The side of the mounting plate

marked “GND” must face out.

The junction box is not included.

CONNECTING THE WIRES (Fig. 2)

4. Connect the electrical wires as follows (Fig.2).

Connect the black wire from the fixture to the

black house (hot) wire; connect the white wire

from the fixture to the white house (neutral) wire.

Make sure all wire nuts are secured. You may

wrap the connections with electrical tape. If your

outlet box has a ground wire (green or bare

copper) connects fixture’s ground wire to it. Other

wise attach the bare copper fixture wire to the

green ground screw on the crossbar. Tuck the wire

connections neatly into the ceiling junction box as

you are holding the fixture assembly toward the

ceiling.

COMPLETING THE ISNTALLATION (Fig. 1)

5. Put the fixture body (C) onto the junction box,

aligning screws on mounting plate with mounting

holes in canopy and lock it securely with the ball

(E).

6. Install the light bulbs (not included) in accordance

with the fixture’s specifications: DO NOT

EXCEED THE MAXIMUM WATTAGE

RATING! (NE PAS DEPASSER LA

PUISSANCE NOMINALE MAXIMALE!)

7. Hook the end of crystals (D) to the bottom hole of

the fixture body (C) and the top hole of the lamp

body (F).

8. Hang the crystals (H) to the bottom loop of the lamp

body (F).

9. Hang the crystals (G) to the middle loop of the lamp

body (F).

Your installation is now complete. Return power to

the junction box and test the fixture.

Fig.1

Fig.2

MIN 90℃ SUPPLY CONDUCTORS

White or

HOUSE

Black

WIRES

(Hot)

Smooth

FIXTURE

WIRES

Black or

Ribbed

WIRES

FIXTURE

Bare Copper(Ground)

FIXTURE

WIRES

Copper

(Ground)

HOUSE

(Neutral)

WIRES

White

Bare

Green or

WIRES

HOUSE

Summary of content (1 pages)

PAGE 1
ASSEMBLING ＆ INSTALLATION INSTRUCTIONS PRODUCT#51864 51866 For Flush Mount Ceiling Fixtures WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER . AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR. MOUNTING THE FIXTURE (Fig.1) 1. Shut off the power at the circuit breaker box. Remove the old fixture and all hardware from junction box. 2. Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.