Instructions / Assembly

ManualsBrandsLivex Lighting ManualsLightingMeridian 2-Light English Bronze Semi-Flushmount

ASSEMBLING & INSTALLATION INSTRUCTIONS

The drawing shown may not exactly match the product enclosed.

However, the installation instructions do apply to this product.

51052 51053 51054 51055 51042 51043

51044 52133 52134 52135 52136

 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.

ASSEMBLING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker box. Remove old fixture and all hardware

from Junction Box.

2. Carefully unpack your new fixture and lay out all the parts on a clear area. Take

care not to lose any small parts necessary for installation.

3. Thread the two mounting screws about 1/4” into the pre-drilled holes in the

mounting plate spaced the same distance apart as the holes in the canopy (I).

4. Attach the mounting plate to the Junction Box with the two Junction Box Screws

as shown. The side of the mounting plate marked "GND" must face out.

The

junction box is not included.

5. Attach the tube(B) to the bottom center pipe nipple of the canopy(I), turn it until

tighten. Attach assembly canopy to the top center pipe nipple of the shade (C), by

turning it clockwise until tight.

6. Thread the pipe nipple (D) into the bottom center coupling of the lamp holder and

lock it securely with the hex nut.

7. Install the light bulbs in accordance with the fixture specifications NOTE: DO NOT

EXCEED THE SPECIFIED WATTAGE!

8. Raise the steel shim (E), glass (F) and plastic shim (G) to the bottom of the shade

(C), aligning the hole with pipe nipple and screw it with the finial (H).

9. While holding the shade assembly towards the ceiling, connect the electrical wires

as Shown in Fig.2, making sure that all wire nuts are secured. You may have to

wrap the connections with electrical tape. If your outlet has a ground wire (green

or bare copper), connect the fixture ground wire to it. Otherwise connect fixture’s

ground wire directly to the mounting plate with the green screw provided. After

wires are connected, tuck them carefully inside the Junction Box.

10. Raise the shade assembly onto the junction box, aligning screws on mounting

plate with mounting holes in canopy (I) and lock it securely with the ball nut (A).

Your installation is now complete. Return power to the junction box and test the

fixture.

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black(Hot)

FIXTURE

WIRES

White or

Ribbed

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

White

(Neutral)

HOUSE

WIRES

Green or Bare

Copper(Ground)

Thank you for purchasing a LIVEX product.

Need assistance with parts or assembly? Please call customer service at: 800-761-8056

Or visit us on-line at: WWW.LIVEXLIGHTING.COM

FIG.2

FIG.1