Installation Sheet

ManualsBrandsLivex Lighting ManualsCeiling LightsProvidence 3-Light Bronze Flushmount with Honey Alabaster Glass

ASSEMBLING & INSTALLATION INSTRUCTIONS

The drawing shown may not exactly match the product enclosed.

However, the installation instructions do apply to this product.

4272 4273 4274 4275 5624 5625 5626 5627

 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.

ASSEMBLING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker box. Remove old fixture and all

hardware from Junction Box.

2. Carefully unpack your new fixture and lay out all the parts on a clear

area. Take care not to lose any small parts necessary for installation.

3. Thread the two mounting screws about 1/4” into the pre-drilled holes in

the mounting plate spaced the same distance apart as the holes in the

canopy.

4. Attach the mounting plate to the Junction Box with the two Junction Box

screws as shown. The side of the mounting plate marked "GND" must

face out. The junction box is not included.

5. Install the light bulbs(Not included) in accordance with the fixture

specifications. NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!

6. Raise the pipe thread of finial(E) insert to the side hole of the glass(D)

and lock it securely with the plastic shim and loop(F).

7. Raise the lamp holder(A) into the glass assembly, use the pipe’s(C)

grapnel hooked the lamp holder’s loop and glass’s loop.

8. While holding the fixture body assembly towards the ceiling, connect

the electrical wires as Shown in Fig.2, making sure that all wire nuts

are secured. You may have to wrap the connections with electrical

tape. If your outlet has a ground wire (green or bare copper), connect

the fixture ground wire to it. Otherwise connect fixture’s ground wire

directly to the mounting plate with the green screw provided. After wires

are connected, tuck them carefully inside the Junction Box.

9. Raise the fixture body’s canopy onto the Junction box, aligning screws

on mounting plate with mounting holes in canopy and lock it securely

with the ball nuts(B).

Your installation is now complete. Return power to the junction box

and test the fixture.

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black(Hot)

FIXTURE

WIRES

White or

Ribbed

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

White

(Neutral)

HOUSE

WIRES

Green or Bare

Copper(Ground)

Thank you for purchasing a LIVEX product.

Need assistance with parts or assembly? Please call customer service at: 800-761-8056

Or visit us on-line at: WWW.LIVEXLIGHTING.COM

FIG.2

FIG.1