Installation Guide

ASSEMBLING &INSTALLATION INSTRUCTIONS PRODUCT# 7390 7391 7392 7393
and 65501 65502 65503 For Ceiling Mount Fixtures
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
MOUNTING THE FIXTURE
1. Shut off the power at the fuse box or circuit breaker box.
Remove the old fixture from ceiling, including the single
bar.
2. Carefully unpack your new fixture and lay out all the parts
on a clear area. Take care not to lose any small parts
necessary for installation.
3. Thread the two mounting screws about 1/4”into the
pre-drilled holes in the single bar, tighten it with the hex
nut; spaced the same distance apart as the holes in the pan
(A).
4. Attach the single bar to the Junction Box using the two
screws from the Junction Box. The side of the single bar
marked "GND" must face out. The junction box is not
included.
5. Hold the pan (A) towards the single bar and connect the
electrical wires as follows (See Fig.2). Connect the black
wire from the fixture to the black house (hot) wire; connect
the white wire from the fixture to the white house (neutral)
wire. Make sure all wire nuts are secured. You may wrap
the connections with electrical tape. If your Junction box
has a ground wire (green or bare copper) connects fixture’s
ground wire to it. Other wise attach the bare copper fixture
wire to the green ground screw on the single bar. Tuck the
wire connections neatly into the ceiling junction box as you
are holding the fixture assembly toward the ceiling.
6.
Finish mounting the pan (A) by placing it over both
mounting screws so that the screws protrude from the holes
in the bottom of the pan (A), lock it securely with the ball
nut(B).
7. Install the light bulbs in accordance with the fixture’s
specifications.
DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!
8. Raise the glass shade(C) to the pan(A), aligning the
salient of pan with glass shade's dint, rotate the glass
shade until tighten.
Your installation is now complete. Return power to the
junction box and test the fixture.
Fig.1
A
C
Junction Box
Box
screw
Single bar
B
(Not included)
Hex Nut
Fig.2
MIN 90℃ SUPPLY CONDUCTORS
DOC20141207390
White or
HOUSE
Black
WIRES
(Hot)
Smooth
FIXTURE
WIRES
Black or
Ribbed
WIRES
FIXTURE
Bare Copper(Ground)
FIXTURE
WIRES
Copper
(Ground)
HOUSE
(Neutral)
WIRES
White
Bare
Green or
WIRES
HOUSE