Installation Guide

ASSEMBLING & INSTALLATION INSTRUCTIONS PRODUCT# HAMILTON
SERIES OUTDOOR POST MOUNT LIGHT FIXTURE
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
ASSEMBLING THE FIXTURE (Fig.1).
1. Carefully unpack new fixture and lay all the parts on a
clear surface. Take care not to lose any small parts
necessary for installation.
2. Put the candle sleeve(F) over the lamp holder.
3. Install the light bulbs in accordance with the fixture’s
specifications. DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!
4. Thread nipple of the finial(A) into cover (B) and lock it
securely with the hex nut(D). Attach the cover(B) onto
the lamp body(E), aligning the cover’s hole with the
mounting screw and lock it securely with hex nut(C).
Wiring (Fig.2)
1. Connect the electrical wires as follows. Connect the
black wire from the fixture to the black house (hot)
wire. Connect the white wire from the fixture to the
white (neutral) house wire. Make sure all wire nuts are
secured. You may wrap the connections with electrical
tape. If your outlet box has a ground wire (green or
bare copper) connect fixture’s ground wire to it.
Otherwise attach the bare copper fixture wire to the
green ground screw on the circular strap.
2. Tuck the wire connections neatly into the junction
box.
Your installation is now complete. Return power to the
junction box and test the fixture.
Fig.1
Fixture
Ground Wire
Fig.2
DOC20141207558
White or
HOUSE
Black
WIRES
(Hot)
Smooth
FIXTURE
WIRES
Black or
Ribbed
WIRES
FIXTURE
Bare Copper(Ground)
FIXTURE
WIRES
Copper
(Ground)
HOUSE
(Neutral)
WIRES
White
Bare
Green or
WIRES
HOUSE