Installation Guide

ASSEMBLING &
INSTALLATION INSTRUCTIONS PRODUCT# 8828-64
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
ATTENTION! COUPER LE COURANT AU FUSIBLE OU LE DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.2)
1. Attach the finial (B) to the fixture center body (C) by turning
it clockwise until tight.
2. Place the glass (G) into the iron frame (D) and press the iron
slices firmly to fix the glass.
3. Attach the iron frame (D) onto the socket of the fixture body
(C) then secure it in, place with ring (E) and screw shell (F)
securely tighten
.
4. Install the light bulbs in accordance with the fixture’s
specifications. DO NOT EXCEED THE MAXIMUM
WATTAGE RATING.
HANGING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove old
fixture and all hardware from Junction Box.
2. Carefully unpack your new fixture and lay out all the parts
on a clear area. Take care not to lose any small parts
necessary for installation.
3. Thread the two Studs (A) about 1/4” into the pre-drilled
holes in the mounting strap spaced the same distance apart
as the holes in the fixture canopy.
4. Install the mounting strap to the Junction Box with the two
Junction Box Screws as shown. The side of the mounting
strap marked "GND" must face out.
CONNECTING THE WIRES (Fig.3)
1. While holding the canopy and lamp cluster towards the
ceiling, making sure that all wire connectors are secured.
You may have to wrap the connections with electrical tape.
If there is a Ground Wire (green or bare copper) in your
outlet box, connect the fixture’s Ground Wire to it.
Otherwise connect fixture’s ground wire directly to the
mounting strap with the Green Screw provided. After wires
being connected, tuck them carefully inside the Junction
Box.
2. Then cover the junction box with canopy, aligning the
Screw of mounting plate with the hole of canopy and lock
it with brass ball (A).
Your installation is now complete Return power to the
junction box and test the fixture.
Fig.1
Fig.2
Fig.3
DOC20141208828
White or
HOUSE
Black
WIRES
(Hot)
Smooth
FIXTURE
WIRES
Black or
Ribbed
WIRES
FIXTURE
Bare Copper(Ground)
FIXTURE
WIRES
Copper
(Ground)
HOUSE
(Neutral)
WIRES
White
Bare
Green or
WIRES
HOUSE
(Not included)