Instructions / Assembly
The 1000W Personal Blender is intended for the following:
• Mixing smoothies and crushing ice cubes.
• Chopping solid foods.
Usage:
• Remove all parts from packing material. Ensure there is not packing
material inside blender cups.
• Clean the device before using it. (Reference Cleaning Instructions)
• Unwind cable from cable spool on the bottom of the device.
• Only operate the blender on a dry, level, non-slip surface.
• Choose a blade and cup size. Fully assemble blender before
plugging in.
o The Cross Blade assembly should be used for mixing whole-
fruit smoothies and chopping ice.
o The Flat Blade should be used for chopping solid foods,
like nuts.
• Do NOT use the flat blade for liquids.
• TIP: For 3 tablespoons of nuts, the blender should run for 8-10
seconds.
Operation:
• Plug in Blender.
• Thoroughly wash all fruit.
• Cut fruit into roughly 1 inch pieces.
• For smoothies, use a 1:1 ratio of fruit to liquid (e.g. water, juice,
yogurt).
• Place all ingredients into Blender Cup. Do NOT allow ingredients to
exceed the MAX marking on the blender cup
• Screw appropriate Blade onto the Blender Cup you are using. Take
care to insure it is securely attached.
• Turn the Blender Cup over and insert it onto the base unit. Fit the small
tabs on the Blender Cup into the corresponding slots on the Base
Unit.
• Turn the Blender Cup slightly clockwise until the device turns on. Do
NOT allow the blender to run for more than 60 seconds.
• Turn the Blender Cup counterclockwise in order to turn the device
off. Do NOT remove until the blade assembly has stopped moving
completely.
• Lift the Blender Cup off of the Base and turn it over so that the Blade
is once again on top.
• Carefully unscrew the Blade and allow any liquid to drip back into