Operation Manual

6
USER'S MANUAL
Split Wall-Mounted Air Conditioner
* Operation and indication sections of remote controller *
NOTE:
* Above figure shows all indications for the purpose of explanation, but practically only the pertinent parts are indicated.When air-conditioner is
cooling-only model, the HEAT is for FAN.
* When TURBO operation is selected,room temperature is not controlled with operation being continually.If you feel the room temperature is too
cool or too heat,please cancel the TURBO operation.
Remote Controller 1
Attention:
1.The appearances of the following two remote controllers will vary,but the functions of the same button are same, Please
check to refer the instructions for the identical remote controller of your air-conditioner.
2.The remote controller 1 and remote controller 2 are the general one used for many types of air-conditioner in our company,
we beg your forgiveness that we would not introduce the button or indicator which is not applicable for units you purchased.
The "LAMP" and "CLEAN" button are applicable for special latest developed new models only instead of normal models.
The "AIR FLOW" button is an optional function button,it just works on those models with three-dimensional air flow function.
AUTO
ON
OFF
COOL
DRY
HEAT
FAN
SLEEP
LAMP
TURBO
CLEAN
HOLD
MODE TEMP
ON/OFF
SLEEP button
This button changes to SLEEP operation.
FAN SPEED button
This button set air rate.
HOLD button
Press this button to lock or unlock the
keyboard.
TIMER button
This button is used to set the switch-on or
switch-off and the timer time.
TURBO button
This button changes to TURBO operation
(It does not work in AUTO,DRY,and FAN
mode.)
TIME indicator
Indicates timer time .
Temperature indicator
Indicates the set temperature.
ON/OFF button
This button, when pressed starts operation
and stops when repressed.
SWING indicator
Indicates selected flap mode.
Indicates the seted air rate.
Indicates during sleep operation.
OPERATION MODE indicator
indicates selected operation mode
SWING
TIMER HOLD SLEEP
FAN SPEED
LAMP CLEAN
OPERATION MODE select button
This button changes the operation mode:
AUTO,COOL,DRY,HEAT,FAN.
FAN SPEED indicator
SLEEP indicator
TURBO indicator
Indicates during TURBO operation.
SET TEMPERATURE button
This button sets the room temperature.
TURBO
Key lock indicator
AIR FLOW
This button used for selection of the left/right
air flow direction,whenever pressed the in
flap will swing or fix(It just works on three-
dimensional air flow model.)
SWING button
This button changes the flap mode:natural
flow ,swing or fixed wind.
AIR FLOW button(optional)