Operation Manual

Icon illustrations:
SET TIMER MODE
AUTO MODE
INDOOR TEMPERATURE
MIDDLE FAN SPEED
HIGH FAN SPEED
RUN INDICATOR LAMP
REMOTE SIGNAL RECEIVER
COOL MODE
FAN MODE
ELECTRIC-HEAT MODE
HEAT PUMP MODE
DRY MODE
SETTING TEMPERATURE
SLEEP MODE
LIGHT-WAVE MODE
LOW FAN SPEED
( ).
Check switch
Emergency
Operation switch
B.
C.
A.
3.EMERGENCY OPERATION SWITCH
In case the batteries in the remote controller are wore out, or remote controller is at fault, use
Emergency operation switch
(Please leave this
button to be used
by the maintenance
staff)
Cooling only type
Every time the switch is pressed, it changes in sequence of COOL STOP.
Heat pump type
Every time the switch is pressed, it changes in sequence of COOL HEAT STOP.
The following table shows the condition of set temperature, fan speed and deflector during
emergency operation.
4.HORIZONTAL LOUVER BLADE
Hold the knob and move the deflector to change right/left airflow direction. Be careful not to adjust
the deflector during operation as the fan is rotating at a high speed and may pinch your fingers.
Mode
Set temperature Deflector
Fan speed
Swing
Swing
Heating
High
Cooling
24
。
C
24
。
C
High
6
Continuing research results in steady improvement. Therefore, This information
and these specifications are subject to change without notice.
NAME OF PARTS
SETTING TEMP or INDOOR TEMP DISPLAY or TIMER DISPLAY