Instructions / Assembly

Page: - 3 - / 3
Step A1: Unscrew the ball knobs (I) from the back plate(E) then gently remove the mounting plate (D).
Step A2: Secure mounting plate (D) to outlet box with mounting screws (A).
Step A3: Make wire connections
Connect wires as below wires connecting shown. TAKE NOTE OF YOUR WIRE COLOR
OF FIXTURE ,NEVER CONNECT WIRE TO GROUND WIRE
Connect ground wire according to below chart Connect wires according to below chart
Twist plastic wire connector until wires are tightly joined together,wrap each connector with approved
electrical tape.Be sure that no wire strands are exposed and then carefully tuck all wires into the outlet box .
Step A4: Align the holes in the back plate (E) with the mounting screws, then attach the back plate
(E) using the previously removed ball knobs (I). Hand tighten until snug.
Step A5: Fix the cloth shade (G) to the socket (H) with the socket ring(F),then screw the tube (K) on
the arm (J).
Install bulbs (Not included. Please do not exceed the maximum capacity recommended on
the socket.)
4. Check everything installed properly, then you could turn on the light. Enjoy !
CLEANING
To clean, wipe fixture with a soft cloth. Clean glass with a mild soap. Do not use abrasive materials such as
scouring pads or powders, steel wool or abrasive paper.
ORDERING PARTS
Keep this sheet for future reference, and in case you need to order replacement parts. All parts for this fixture
can be ordered from place of purchase. Be sure to use exact wording from illustration when ordering parts.