Installation Guide

[phone] Working hours : Mon - Fri 9:00 a.m. - 16:00 p.m. EST [e-mail]
www.ihomeangel.com Page: - 4 - / 4
8. Make wire connections
Connect wires as below wires connecting shown. TAKE NOTE OF YOUR COLOR OF FIXTURE ,NEVER
CONNECT FIXTURE WIRES TO GROUND WIRES
Connect ground wire according to below chart Connect wires according to below
chart
Twist plastic wire connector(C) until wires are tightly joined together,wrap each connector with
approved electrical tape for more secure connection and carefully stuff all wires into the outlet box
9. Remove the knob balls (G) from the mounting plate assembly (A).
Fit the canopy (E) to the mounting plate assembly (A)
and secure with the ball knobs (G)
Note: The canopy (A) should be snug against the
ceiling and the mounting balls. If not, adjust the length
of the nipples on the mounting plate assembly (A) by
unscrewing the preassembled hex nuts and then screwing
the mounting screws in or out of the mounting plate until the
length is achieved. Tighten the hex nuts and proceed to step 9
10. Check everything already is installed properly, then you could turn on the light. Enjoy!
CLEANING
To clean, wipe fixture with a soft cloth. Do not use abrasive materials such as scouring pads or powders, steel
wool or abrasive paper.
ORDERING PARTS
Keep this sheet for future reference, and in case you need to order replacement parts. All parts for this fixture can
be ordered from place of purchase. Be sure to use exact wording from illustration when ordering parts.