Instructions / Assembly

4. Secure the mounting plate(F) to outlet box with mounting screws (D),
plastic anchors (E) and wood screws (G)
5. Make wire connections
Connect wires as below wires connecting shown. TAKE NOTE OF YOUR WIRE COLOR OF FIXTURE ,NEVER CONNECT
WIRE TO GROUND WIRE
Connect ground wire according to below chart
Connect wires according to below chart
Twist plastic wire connector until wires are tightly joined together, wrap each connector with approved electrical tape and
carefully tuck all wires into the outlet box
6. Raise the canopy (H)to ceiling and secure canopy(H)
in place by tightening threaded balls(C) onto screws
7. Loosen the stud (I)on joint to adjust the angle of fixture,
once desired angle of fixture is achieved, tighten the studs(I).
Install bulb (Not included. Please do not exceed the
maximum capacity recommended on the socket.)
8. Check everything is already installed properly, then you could turn on the light. Enjoy !
CLEANING
To clean, wipe fixture with a soft cloth. Do not use abrasive materials such as scouring
pads or powders, steel wool or abrasive paper.
ORDERING PARTS
Keep this sheet for future reference, and in case you need to order replacement parts. All parts for this fixture can
be ordered from place of purchase. Be sure to use exact wording from illustration when ordering parts.
Page: - 3 - / 3