Installation Guide

[phone] Working hours : Mon - Fri 9:00 a.m. - 16:00 p.m. EST [e-mail]
www.ihomeangel.com Page: - 3 - / 4
4. Carefully pass the wires through the moungting plate assembly(B)
Attach the mounting plate assembly(B) to ceiling with mounting screws(D)
5. Place the handles (E) onto the fixture and secure with hex nuts
By measuring, determine the correct depth of center rod
screwed into the fixture, then screw the center rod in or out .Once
the proper depth is achieved,tighten the hex nut.
6. Make wire connections
Connect wires as below wires connecting shown. TAKE NOTE OF YOUR WIRE COLOR OF FIXTURE ,NEVER CONNECT
WIRE TO GROUND WIRE
Connect ground wire according to below chart Connect wires according to below chart
Twist plastic wire connector until wires are tightly joined together,wrap each connector with approved electrical
tape.Be sure that no wire strands are exposed and then carefully tuck all wires into the outlet box .
7. Fit the fixture to the mounting plate assembly (B)
and secure with the ball knobs (G)
Note: The fixture should be snug against the
ceiling and the mounting balls. If not, adjust the length
of the nipples on the mounting plate assembly (B) by
unscrewing the preassembled hex nuts and then screwing
the mounting screws in or out of the mounting plate until the
length is achieved. Tighten the hex nuts and proceed to step 7